4DRC 4D -V32 Manual do utilizador - Página 16
Procurar online ou descarregar pdf Manual do utilizador para Drones 4DRC 4D -V32. 4DRC 4D -V32 16 páginas. Four axis aircraft
Correct gestures
Incorrect gesture
18.5 MV interface:
Click on the "Filter Interface" icon in the APP control interface (Figure 18) to enter the
filter interface. You can choose to match your favorite filter effect, click on the recording
icon, and start recording (Figure 19). After recording, the synthesized short video or
picture will be saved to the media library (Figure 20).
Special reminder: During the recording process, the screen can be rotated or the
filter effect can be switched. The joystick can also be turned on/off to control the
direction and height of the aircraft.
Figure 18
19. Guidelines for Solving Common Problems
Problem
Aircraft indicator light
flashing, no response
during operation
Aircraft blades rotate
but cannot fly
The flight shook violently 1. Blade deformation
Fine tuned to the bottom,
but still unable to stabilize
the aircraft
Starting the aircraft again
after impact and flying
uncontrollably
【 Gesture photography】
About 2m in front of the aircraft lens, lift the palm of one hand
(palm facing forward) flat on the side of the body; After the
aircraft recognizes the gesture, it starts a 3-second countdown
and takes a photo (at this point, the arm can be lowered) (the
time difference between two consecutive recognition should
be greater than 3 seconds) (Some models do not support this
function, and turning on the function will cause a delay in the
image).
Incorrect gesture
【 Gesture recording】
About 2m in front of the aircraft lens, clench your fist with one
hand (palm facing forward) and lift it flat on your side; After the
aircraft recognizes the gesture, a 3-second countdown begins
and the recording begins (at this point, the arm can be
lowered). When recognizing the fist gesture in the recording,
the recording ends. (During the recording, the palm is not
detected).
Correct gestures
Figure 19
Reason
1. The aircraft's battery is
low
1. Low battery level
2. Blade deformation
3. AB blade installation error
1. Blade deformation
2. The motor is not working
properly
1. Three axis acceleration
sensor loses balance due
to impact
-15-
Resolvent
1. Charging the battery
1. Charging the battery
2. Replace the fan blades
3. The fan blades are printed with letters A and B.
The A fan blades are replaced with A, while the
B fan blades are damaged and replaced with B.
1. Replace the fan blades
1. Replace the fan blades
2. Replace the motor
1. After the aircraft has been left stationary for 5-10 seconds,
or through horizontal calibration, it is sufficient. (Refer to
10.3 Horizontal Calibration Operation for steps)
Figure 20