4F Maschinentechnik Limpar SP-94 Manual de instruções - Página 10
Procurar online ou descarregar pdf Manual de instruções para Equipamento para relva e jardim 4F Maschinentechnik Limpar SP-94. 4F Maschinentechnik Limpar SP-94 14 páginas. Slat scraper
Imprimir páginaIf it is necessary to clean the scraper implement thoroughly, separate it from the
basic device. As a separate part, you can clean it without qualms using a high
pressure jet or steam.
Floor blades: These parts are made of high quality plastic which has proven itself
in agriculture. If the blades are worn, the rear one can be turned once. The rear
scraper is turned on its head. The front scraper must be replaced, as it is
unsymmetrical.
When screwing the "fresh edges" tight, place the implement on a level surface.
4.2 Machine settings
Check the Bowden cable for ease of movement. (If necessary, lubricate with
normal penetrating oil.) The operating lever must be securely disconnected by the
restoring forces of the drive mechanism. If the Bowden cable needs adjustment,
this should be done on the adjustment element mid way along the cable.
The Bowden cable is correctly adjusted if the machine allows itself to be pulled
back easily, and if at activation the springs on the lower end are extended approx.
3-5 mm.
Scraper implement: Both floor blades must make full contact when the floor is
level. The upper bolts in the implement socket are located in slotted holes, and
allow the main unit to tilt relative to the implement.
Tyre pressure: The slat scraper's wheels are equipped with car valves. The
correct tyre pressure is approx. 1.8 bar.
4.3 Taking the machine out of service for an extended period
Please consult your specialist dealer if the slat scraper will not be used for an
extended period. S/he will suggest the appropriate steps.
5. Questions and answers
5.1 Q: The motor does not run; what could be the reason?
A: Battery is flat; connect the charger and check the battery status.
See point 7.
A: The overload fuse has tripped (point 3.2 and 4.1) after 15 s press button in.
5.2 Q: Why does the machine not pull correctly anymore?
A: The batteries are no longer sufficiently charged. Possibly spent?
See point 7.
A: The Bowden cable must be adjusted. If resetting does not solve the
problem, consult your specialist repair shop.