Abusemark NAZE32 Manual de configuração - Página 2
Procurar online ou descarregar pdf Manual de configuração para Acessórios para drones e quadricópteros Abusemark NAZE32. Abusemark NAZE32 4 páginas. Radio gear
Imprimir páginaConnect output side of the cable to SBUS output terminal of your SBUS receiver
Connect flight controller to usb and run base flight software, from the configuration page of the app.
choose SBUS serial receiver and click SAVE, go to RECEIVER page and change Channel map to
FUTABA/HITEC, click SAVE
If using Futaba gear, center might be 1520. In that case, set MID THROTTLE(RC input middle point) value
in CONFIG PAGE of base flight app to 1520, then subtrim to center all channels at 1520. Do not use trim
in flight for either gyro or auto-level mode.
Check that all channels are moving accordingly in the channel graph of RECEIVER page in application.
Spectrum Satellite Binding:
You may install prebound satellite to your model
Bind it using a main receiver as usual
connect to the flight controller satellite extender wire connector
Or you can bind it without main RX right on the Copter
•
Make sure that satellite has been connected correctly.
•
Connect Naze32 to USB (No need to connect your POWER BATTERY)
•
Open baseflight software and connect to Naze32 (baseflight app in Chrome)
•
From Configuration tab make sure that you have selected "Enable Serial-based receiver" and
Serial receiver is correct (e.g. SPEKTRM2048 for DSMX)
•
From CLI tab type: "set spektrum_sat_bind = 9" for DSMX or "set spektrum_sat_bind = 5" from
DSM2
•
type "save" and after Naze32 reboot remove USB cable (=Power off the Naze32)
•
Wait a sec and reconnect the USB cable. After cold start satellite led should start blinking and
transmitter should be turned on while pressing the bind button.
•
After binding satellite led should be solid. Connect baseflight and use receiver tab to test that
satellite is working correctly.
•
Final step is to go to CLI tab and type "set spektrum_sat_bind = 0" and then type "save". This
must be done so that satellite doesn't go back to binding mode when Naze32 is repowered
again.
Gaupner SUMD:
Simply connect SumD, wires ground to Gpin, power to +5v marked as «•» and pin4 for
signal(bottom row of pins).
Set the serial receiver to SUMD in Baseflight app configuration menu.
In a receiver tab of base flight app test that SUMD receiver is working correctly.