Duro Dyne MINI-SPRAYFAST 39047 Manual do Proprietário

Procurar online ou descarregar pdf Manual do Proprietário para Pulverizador de tinta Duro Dyne MINI-SPRAYFAST 39047. Duro Dyne MINI-SPRAYFAST 39047 2 páginas. Adhesive applicating system for water-based adhesives
Também para Duro Dyne MINI-SPRAYFAST 39047: Manual do Proprietário (2 páginas)

Imprimir página

MACHINERY

DIVISION

SET- UP AND OPERATION

Your Duro Dyne Mini Sprayfast is shipped completely assembled and ready to use.

Place the pickup tube in the pail of Duro Dyne WIT or WSA Water-based adhesive.

NOTE: DO NOT USE THE MINI SPRAYFAST WITH SOLVENT BASED ADHESIVE. DOING SO WILL RENDER THE

UNIT INOPERABLE AND UNREPAIRABLE.

Adjust both regulators of your Mini Sprayfast to 70 PSI. The pump will start cycling and then stop when fully

primed. Pull the trigger on the spray gun to dispense the adhesive. The Mini Sprayfast pump should cycle pe-

riodically to maintain pressure. Excessive cycling indicates too little available air. Check for restrictions in your

air supply or compressor capacity.

The Spray Gun manufacturer's operation manual is included for proper adjustment, operation and maintenance

of the spray gun.

CLEAN UP

At the end of the day or prior to an extended period of non use – Place the pickup tube in a bucket of warm

water and spray through the unit for a minimum of one minute to glush out the unit.

MINI-SPRAYFAST

ADHESIVE APPLICATING SYSTEM

FOR WATER-BASED ADHESIVES

OWNER'S MANUAL

Congratulations on your purchase of a Duro Dyne Mini

Sprayfast Water-based adhesive spray applicator.

With careful attention to setup and maintenance it

should provide you with years of trouble free service.

Should you encounter any difficulties you should

contact your local Duro Dyne Distributor or Territory

Manager or you can call our Technical Services Dept.

on our toll free number: 1-800-899-3876.

ITEM # 39047

™