Data-Tronix DT-ATSC-IP-8 Manual do utilizador e manual de instalação - Página 7
Procurar online ou descarregar pdf Manual do utilizador e manual de instalação para Hardware de rede Data-Tronix DT-ATSC-IP-8. Data-Tronix DT-ATSC-IP-8 15 páginas. 8 input atsc/qam to ip processor
Imprimir páginaDevice Programming and Setup via GUI Interface
Connecting to the GUI Interface
Factory Default IP: 192.168.1.9
◊ Connect an Ethernet cable directly (no Cross Over cable required) to the UTILITY Port on the rear panel of the
encoder or connect the Ethernet cable to an Ethernet switch. Connect an Ethernet Cable to your PC/Laptop.
◊ Modify your PC/Laptop IP address to 192.168.1.11.
◊ Enter '192.168.1.9' into your web browser.
◊ Enter GUI and make required device changes.
◊ Save all changes as required, upload and reboot changes.
◊ Verify parameters then end web session.
Overview Page
Overview Page will provide an overall system status of the DT-ATSC-IP-8 Converter state: Signal Strength and Signal
Quality.
System Parsing / Response Time:
The initial System Parsing time will range from 3-4 minutes on average as the system identifies and
populates the required parameters.
As the user navigates the device's menu note that a small delay may occur in populating the data on the screen as the
system is constantly performing system parsing and system housekeeping functions.
NACE:
610-429-1511
| [email protected] | www.datatronix.biz | | DT-ATSC-IP-8 Manual v1.0
Page 7