DataBay ET-DF0101-RG500 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Extensor DataBay ET-DF0101-RG500. DataBay ET-DF0101-RG500 8 páginas. Dvi fiber optic extender kit (multi-mode lc type)
Imprimir páginaInstallation
Important: Please use the installation procedure below. Improper, or no
operation may result if the start-up sequence is not correctly followed.
Installation Step
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Connect each duplex LC fiber cable one by one as indicated number. The channel "1"
of TX corresponds to channel "1" of RX. The other channels are the same connection.
Step 3
Connect the AC/DC adaptor to the RX module.
Neglect AC/DC adaptor to the TX module. The PC may supply voltage source via DVI
receptacle.
Step 4
Plug directly the TX module in the DVI receptacle of PC. Do NOT use any
intermediate cable or adaptor between them.
Step 5
Plug the RX directly module in the DVI receptacle of display. Do NOT use any
intermediate cable or adaptor between them.
Step 6
Power on the PC and display.
：
Note1
The set-up of screen might be fitted to the display resolution. It is certain to happen such
unfitness if it is first time to boot up in using this extender module. Then, go to Display Properties in
Windows systems and click the tap of Settings. Then you can set the right display resolution to meet
your display. Once you set the right resolution, you could see displaying the initial screen at the same
resolution as just before you powered on.
：
Note2
You might not use the AC/DC adaptor at TX module, but use the power supplied through a DVI
pin from the graphic cards. After completing the installation instruction, if the system doesn't work
properly, you could re-connect the AC/DC adaptor while all powers for the system are ON
Multimode Fiber (4LC)
Figure 3 Installation of Optical DVI extender
- 4 -