ELRO LP152012 Manual - Página 2

Procurar online ou descarregar pdf Manual para Acessórios ELRO LP152012. ELRO LP152012 2 páginas. Motion sensor

Imprimir página

(1) TEST MODE



Turn the LUX control and the TIME control

counter clockwise to the edge – the TEST

position.



Turn on the wall switch. The light starts warm-up

for 1 minute. During 1 minute warm-up period, the

light will stay on.



Walk through the detection area. The light turns

on when you move and turns off when you stop.



For a smaller coverage area, point the sensor

down; for a larger coverage area, point the sensor

up.

(2) TIME ADJUSTMENT

The TIME adjustment controls how long the light will

stay on after the motion has been detected.

About 5 seconds

(3) LUX ADJUSTMENT

The LUX adjustment determines at what light level the

lighting system will start operating when you set the

sensor to automatic operation.

(4) AUTOMATIC OPERATION

Turn on the wall switch. When the sensor detects

motion, the light automatically turns on. The built-in

photocell turns the sensor off and on according to the

light level selected by the LUX adjustment.

About 12 minutes

(5) MANUAL OVERRIDE CLICK TWICE

Automatic switching can be overridden to allow the

lighting to illuminate regardless of movement or light

sensitivity. Turn the switch OFF - ON - OFF - ON

within 2 seconds.

In manual override mode, the lighting will remain on

for approx. 4 to 6 hours regardless of movement. Then

the motion switch will return to automatic mode.

You can also manually set the motion switch to

automatic mode by turning it off for 10 seconds, and

then on again.

TROUBLESHOOTING

Light does not turn on:



Confirm that you have made a correct "wiring

connection".



Check if you have already turned on the

connected wall switch, or circuit breaker.



Examine if the bulb of the lighting system is in

good condition or loose.



Adjust the LUX control knob by turning it counter

clockwise.

Light remains on:



Make sure the wiring connection is correct.

SPECIFICATIONS

Power Requirement

Lighting Load

Detection Field

(at 20°C)

Swiveling Angle

Mounting Height

Sensor Operation

Time Adjustment

Lux Adjustment

Warm Up Time

Protection Class

Protection Degree

Safety

AC 220 ~ 240V / 50Hz

Up to 1000W Halogen/

Incandescent

Up to 400W Fluorescent

Up to 150W LED

Up to 200° and 12 meter

Vertical 35° Horizontal 70°

1.8 ~ 2.0m Wall Mount

or 2.5 ~ 4.0m Ceiling Mount

Auto/Manual Override

Approx. 5 sec ~ 12 min

Approx. 30 ~ 200 Lux

About 1 min.

IP44