Addvent AVACSPL18N Instruções de instalação e manual do utilizador - Página 5

Procurar online ou descarregar pdf Instruções de instalação e manual do utilizador para Ar condicionado Addvent AVACSPL18N. Addvent AVACSPL18N 17 páginas. Split air conditioners

Imprimir página

AVACSPL12+18Ninstructions

Installing the indoor unit

Positioning the mounting plate

Install directly on the wall

G Select a structural part of the wall, so that indoor unit can be installed

securely.

G Make sure the mounting plate is level before securing it.

The wall must be capable of carrying the weight of the indoor unit.

Note: The indoor unit must be installed more than 2.3m above the ﬂoor for the best

efficiency.

Install the piping hole

G Drill hole with 65mm core drill.

G Insert the through wall pipe into the hole

Note: Drill the hole from indoors to outdoors with a 5° downward inclination.

Indoor unit installation preparation

Install the drain hose

G Run the drain hose sloping downward.

Do not install the drain hose as illustrated (see ﬁgure 7).

G When connecting extension drain hose insulate the connecting part of

extension drain hose with a shield material.

Indoor unit electrical wiring

G The indoor unit electrical wiring is already connected to the indoor unit

during manufacture.

G If the wiring or any other part is damaged, please contact Addvent on

0117 923 5375.

Wrap the pipe and wiring.

G Hold down the end of the pipe, pull it out, form the extension part.

G Wrap the piping and wiring and pull them through the cut-off-tailings hole.

G When routing the pipe and wire from the left or right side of the indoor

unit, cut off the tails from the pipe holder if necessary.

NOTE: EMC Directive 89/336/EEC to prevent ﬂicker impressions during the start of

the compressor (technical process) and the adverse inﬂuence caused by the

second harmonics of the compressor, the following installation conditions apply.

The power connection for the air conditioner has to be done at the main power

distribution. The distribution has to be of a low impedance, normally the required

impedance reaches at a 32A fusing point.

No other equipment has to be connected with this power line.

For detailed installation acceptance, please refer to your contractor with the power

supplier if restrictions do apply for products like washing machines, air conditioner

or electrical ovens.

For power details of the air conditioner, refer to the rating plate of the product.

For any further questions contact Addvent on 0117 923 5375.

12/3/08

09:06

Page 5

Figure 6

Figure 7

Figure 8