ELS-Storage S-36WM Manual do utilizador - Página 2
Procurar online ou descarregar pdf Manual do utilizador para Armazenamento ELS-Storage S-36WM. ELS-Storage S-36WM 2 páginas. Backplane
Imprimir página---Front Panel--- (see picture D)
---Rear View--- (see picture F)
D.1--- Reset Switch for buzzer alarm
D.2--- D.4 (HD1〜HD3, Power SW and LED): Power
D.5--- Fan sensor LED:
D.6--- Carrier Safety Lock
Picture E
Rear View Description (Picture F):
POWER1: 4pin Power connector
POWER2:
connection (4pin power & 15pin SATA power). Use the 4pin power
connector, or the 15pin power connector. (Note: Can mix using 4pin
and 15pin powers. Suggestion: At least 2 power).).
HD1— HD3:
lJP1:
lJP3:
J4:
LED Switch
and over- heating LED
When overheating occurs(default setting is 60 ) the buzzer
alarms and the temperature LED turns red, meanwhile, buzzer
is alarming and LED is blinking). Press the Reset Switch to stop
the alarm, and LED goes off.
on, LED indicates Green. Orange color blinking for HDD
access)
powered on. When fan failed, LED turns Red.
The safety lock safeguards the hard disks in the correct
position and prevents it bouncing out while HDD is
working. (see Picture E).
15pin Serial ATA Power connector [ Two types power for
7pin Serial ATA Signal connector
Temperature setting jumper
Extension function jumpers (see left chart)
FLEDR: Fan failure detection (red)
FLED+: Fan failure detection (+)
FLEDG: Fan failure detection (green)
RESET: Reset Switch for buzzer alarm and Overheating LED
TLEDR: Temperature detection (red)
TLEDG: Temperature detection (green)
[ [High 3000rpm & LOW 2300 rpm ]
Fan High/Low switch
a) When LED switch is set to "enable "position", LED indicates Green
when powered on and Orange color blinking for HDD accessing
[ In this case, the HDD does not spin up until the SATA initial
signal is received ].
b) When LED switch is set to "disable" position, LED always indicates
SOLID GREEN both for HDD being powered on and HDD being
accessing. [ In this case, the hard drive is spinning up when the
system power is turned on ].
℃
LED indicates Green when
( default setting is 60℃)
5V+:
5V Power
GND：
Grounded