Durston Tools Quad Ringer Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Durston Tools Quad Ringer. Durston Tools Quad Ringer 12 páginas.

• Wear eye protection

• This is a high-speed cutting tool and could lead to serious injury if not used correctly

• Observe all safety instructions

• Attach the handpiece to the flex shaft only when you are making your cut and remove immediately

after use

• The blade must be set to that it cuts the coil upwards against the coil holder lid

• Check that the motor is set to Forward

The cut is not smooth

If your blade is not cutting smoothly stop the motor immediately and check you have set up your ringer

correctly. This will avoid spoiling the whole coil. Check your blade for wear/damage.

The final part of the cut fails

If the coil collapses at the end of the cut this is because the coil is not fully supported by the stop pin. Use a

piece of dowel trimmed to match the diameter of your coil as shown in the instructions.

Rings shoot out of the coil holder

Use the deepest channel available so the coil is just above the top side of the coil holder. A piece of masking

tape over the coil will help to keep the jump rings in the coil holder. Trim excess tape from the sides of the

holder.

Place the coil holder lid over the coil and tape.

Remember

Problem Solving