Elsema iS2000 Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Abertura de portões Elsema iS2000. Elsema iS2000 7 páginas. High speed sliding gate
opener
elsema’s eclipse
control card with gds operator
Também para Elsema iS2000: Manual do utilizador (8 páginas)
Imprimir página1.
S
P
AFETY
WARNING!
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTALLATION
INSTRUCTIONS COULD RESULT IN INJURY OR DEATH AND
.
EQUIPMENT
Appropriately licensed and competent personnel only should install the automation equipment.
•
The operators are designed specifically to open and close sliding gates or doors and should not be used for
•
any other purpose.
Before commencing installation, read through this installation manual.
•
Check that the operator and controls are in new condition and have not been damaged in transit.
•
Check the gate or door and it's associated support posts and walls to protect against shearing, compression
•
and other various traps which could cause serious injury or death. Take into consideration the general
installation and surrounding environment.
Check the gateposts or mounting structure has the necessary strength and rigidity to support the operator
•
and the load of the opening and closing gate motion.
CAUTION!
Always incorporate the appropriate Photo Electric Cells, Induction Loops and any other safety
devices to protect both equipment and personnel. Extra caution should be employed when using
operator in auto close mode.
Display any necessary signs to indicate any danger areas and automatic operation of the gate or door.
•
The operators are not designed to be used in any hazardous areas or areas subject to flooding etc.
•
All electrical connections and wiring must be performed with AS/NZS 3000-2007 as the guidelines. (Or its
•
counterpart for other countries outside of Australia and New Zealand)
WARNING! ELECTRICITY CAN KILL
The manufacturer of the automation equipment is not responsible for the damage which may be caused to
•
either the operator, gate or door and any other person or equipment when: -
o Wrong or poor installation practices were performed.
o No or inadequate safety devices were used.
o Either the surrounding structure or the gate or door strength and rigidity was not sufficient for the
task in hand.
o Inefficient locking devices were employed.
o Poor maintenance on the equipment.
o Any other circumstances beyond the manufacturers control.
Isolate power before attempting any maintenance, qualified personnel only to carry out maintenance
•
Only original spare parts are to be used should there be a requirement for them.
•
Keep loose clothing and hands clear of the gate whilst in operation or potentially able to be operated.
•
The installer should provide all information concerning the use of the automation equipment as well as
•
instructions regarding the manual override and maintenance procedures to the users of the system.
RECAUTIONS
/
OR DAMAGE TO PROPERTY AND
3