Elsema G-2000 Manual - Página 12
Procurar online ou descarregar pdf Manual para Recetor Elsema G-2000. Elsema G-2000 13 páginas. 3g receiver with relay output for opening sliding, swing gates, doors or switching devices
Imprimir página
Reset the Password of the G-2000 to factory default.
Press and hold the reset button, connect the power and then slide the switch to "ON". After 6 seconds the
Network LED will blink 5-6 times to indicate the password has been reset. Release the reset button and do a
power cycle.
This will only reset the password to factory default. It will not change any other settings. All other settings can
only be changed by PC software.
Power ON
12VDC power Led indicator.
The LED lights up when the inputs are triggered and there is alarm condition.
Alarm ON
Relay ON
The LED lights up when the relay switches ON.
Flash every 1 Second: Registering to the mobile network or looking for network
Flash every 2 Second: Successfully connected to the network. Normal status.
Network Signal
OFF: Unregistered network or cannot connect to the network.
Power
9 - 24 Volts DC. Use the power pack supplied
Input 1
Dedicated normally closed (NC) input for door switch.
Digital input 2. Can be used to connect Reed switch, PIR, fire alarm or any other dry
Input 2
contact switch.
Relay Output
Common (C) and Normally Open (NO) relay outputs rated at 3A, 240VAC.
Siren
12 Volts DC output to connect siren or flasher lights or any other 12VDC device
www.elsema.com
Block Diagram
Page 12
ELSEMA
3G Receiver with relay output, G-2000