Elsema G-2025 Manual - Página 13
Procurar online ou descarregar pdf Manual para Recetor Elsema G-2025. Elsema G-2025 14 páginas. 4g receiver with relay output for opening sliding, swing gates, doors or switching devices
Imprimir página
Reset the Password of the GSM receiver to factory default.
Slide the switch near the SIM card to OFF position and disconnect the power. Press and hold the reset button,
connect the power and then slide the switch to "ON". After 6 seconds the Network LED will blink 5-6 times to
indicate the password has been reset. Release the reset button and do a power cycle.
This will only reset the password to factory default. It will not change any other settings. All other settings can
only be changed by PC software or SMS.
Power ON
Power ON indicator.
Alarm ON
The LED lights up when the inputs are triggered and there is alarm condition.
Relay ON
The LED lights up when the relay switches ON.
Flash every 1 Second: Registering to the mobile network or looking for network
Flash every 2 Second: Successfully connected to the network. Normal status.
Network Signal
OFF: Unregistered network or cannot connect to the network.
Power
9 - 24 Volts DC. 12v DC Power pack supplied
Can be used to connect Reed switch, PIR, fire alarm or any other dry contact switch.
Inputs 1 & 2
Inputs can be changed to Normally Closed (NC).
Relay Output
Common (C) and Normally Open (NO) relay outputs rated at 3A, 240VAC.
DC output to connect siren or flasher lights or any other device. Siren voltage output is
Siren
the supply voltage used to power the GSM receiver.
www.elsema.com
Block Diagram
Page 13
ELSEMA
4G Receiver with relay output, G-2025