Cayken KCY- 130/3WDO Instruções de funcionamento - Página 5
Procurar online ou descarregar pdf Instruções de funcionamento para Perfurar Cayken KCY- 130/3WDO. Cayken KCY- 130/3WDO 13 páginas. Versatile magnetic drill
Imprimir página
10.The company factory hollow drill are equipped with cooling kettle, please put the kettle
arranged on the corresponding position before operating the machine, and tighten the two
round head screw. The kettle is connected after please figure two (035), fittings is screwed on
the hydrosphere, tighten the end can be on the frame by.
11.After 300 hours of operation, the gear lubricating oil should be replaced.
GROUNDING DEVICE
This tool should be properly grounded, in order to avoid the shock. Grounding device
should have the lead standard, and a grounding plug with earthing special line. Do not be
ground false joint in the line of fire or three-phase line. Grounded power receptacle should
be connected withthe earthing device is connected to the eternal, so that it can work with
yellow green wire connected to the plug hole and connection piece at the same time and
ground connection.
QUALITY ASSURANCE
Consumers buy our machines produced within twelve months, enjoy free maintenance
and warranty service. During normal use of the whole or parts of any manufacturing process
or product failures caused by components, please present the original invoice, the dealer sta-
mped and filled properly warranty certificate to the Company or the Company's designated
repair station to receive free services. machine consumable normal wear and tear, overload,
do not operate according to operating specifications, disassemble, damage caused as a result
of use of parts other than the Company and damage, are not covered by warranty. warranty
expires,provided by the designated repair station maintenance service. maintenance records
must be sealed or signed by the repair station to take effect.
FAULT HANDING
FAULTS
Magnetic base
without suction
Machine did not
run after the jump
Magnetic little
suction
Turn the handle gu
ide does not work
Drill out the
elliptical hole
Spindle shake
Electric ignition
Warning: magnetic drill equipped with a safety rope, when operating, make sure
the magnetic drill and the object is fastened by the rope.In case of power
failure suddenly, causing the machine fall off or thrown objects and
cause accidents.
Attention: Our company does not assume any responsibility because the machine
is not solid or fixed safety facilities are not in appropriate place cause
accident.
5
6
CAUSES
ELIMINATION METHODS
Switch contact undesirable
Repair the switch
Power supply is broken
Repair the power supply
The fuse burn out
Replace the Fuses
Repair or replace the magnetic bridge
Electromagnet short circuit or burn out
Adsorption not on the steel frame
Change the adsorption surface
Switch contact undesirable
Repair and change switch
Joint loose
Check the electric drill part connector
Repair or replace the electric brush
Brush and commutator poor contact
Drill the armature or stator coil burn out
Changing the armature or stator
Replace the adsorption surface or thickening adsorption surface
Adsorption artifacts thin
（>10mm steel sheet）
Replace the adsorption surface or temporary welding
Adsorption on the surface is small
thick surface adsorption
Support bar top tight
Support bar between the adsorption surface
Diode may be virtual welding
Re Welding
Shaft key cut
Replace the shaft key
Wheel and rack misplace
Unscrew the rack bottom screw
For a drill and a fastener is loose
Correction of verticality tighten the fasteners
Grind anew
Bit unilateral cutting
Adsorption surface have sundry
Eliminate clutter
Frame adjusting screw loose
Tighten adjusting screws
The spark turns orange.
Slow down.
Sparks flying out.
Change the brush, please.
Sparks into a ring of fire
Please check if the motor is burned.
,
remove guide to repair