Datalogic Magellan 1100i OEM Manual de integração - Página 8
Procurar online ou descarregar pdf Manual de integração para Leitor de código de barras Datalogic Magellan 1100i OEM. Datalogic Magellan 1100i OEM 16 páginas. Presentation omnidirectional bar code reader
Também para Datalogic Magellan 1100i OEM: Manual de integração (16 páginas)
Imprimir página
Mounting the Scanner Standalone
The OEM scanner is not intended for use in a standalone application. This
model is intended to be integrated inside a host enclosure. Standard Magellan
1100i models should be used when a standalone application is required.
Cable Routing
The mounting design should also take into consideration the clearances needed
for the interface cable. This cable should be routed internal to the host enclo-
sure as much as possible. It is recommended to use a flat cable or round cable
without a large strain relief so that the cable can be routed away from the scan-
ner in one of the following directions. As shown in
can be routed out the rear or bottom surfaces of the scanner.
Figure 1. Cable Routing
Scanner Ventilation
When mounting the scanner inside a secondary enclosure, it is important to
have proper ventilation to ensure that the scanner temperature does not exceed
the maximum range as listed in
ability of the scanner may be compromised if the temperature range is not
maintained.
Integrating the Scanner to Read at the Proper Distance
When deciding how to mount the OEM scanner, there are many criteria that
must be considered. First, there are minimum and maximum distances that the
bar code can be from the front of the scanner to be properly read, depending
on the size of the bar code. These distances, or depth of field, are specified in
Appendix A, Technical
Note that the depth of field begins 13mm [0.5"] from the front of the scanner.
This means that bar codes may not be read if they are within the range of 0-
13mm [0-0.5"] from the front of the scanner. To ensure that a bar code can not
be placed too close to the scanner, it is recommended that the scanner is
mounted at least 13mm [0.5"] from the outer surface of the host enclosure, to
ensure that bar codes will be within the scan volume.
2
Rear Cable Routing
Appendix A, Technical
Specifications.
Figure
Bottom Cable Routing
Specifications. The reli-
Magellan™ 1100i OEM
1, the interface cable