Dustbane Gladiator 464 Manual de operação - Página 13
Procurar online ou descarregar pdf Manual de operação para Varredor de relva Dustbane Gladiator 464. Dustbane Gladiator 464 16 páginas. Gladiator series
Imprimir página15. Cleaning and Servicing the Filters
The filters are very important components of the machine and essential for correct operation. Proper filter
maintenance will allow you to obtain the best performance from your machine.
Pre-Filter
Clean Daily
1. Remove the debris hopper to access the pre-filter
2. Release the two metal retaining clip arms that secure the pre-filter in place. Hinge the retaining clip arms
outward and remove the pre-filter.
3. Shake the pre-filter into a debris receptacle.
4. Replace the pre-filter and secure with retainer clips.
Main Filter
The Main filter can be cleaned in any of the following three ways:
1. by means of the automatic filter shaker:
During operation, the machine will automatically activate the filter shaker every 3 minutes.
2. by means of manually activating the filter shaker:
Just a simple command is needed to keep the filter in perfect working order: press the button
marked 'E' and hold it down for a few seconds. Repeat this operation 4 or 5 times. Remember that
the cleaner the filter, the better the results of your cleaning session. It is recommended to
carry this operation out at the end of each work cycle.
NOTE: dusty environments If you are using the machine in a dusty environment it is a
3. by manually cleaning the filter:
Manually clean the filter when the filter shaker is not enough to keep the filter clean and/or every
20 hours of work. Before carrying out any kind of procedure on the machine, make sure it is
turned off and that all functions are deactivated
1. Remove the rear hopper
2. Take the filter out
3. Blow compressed air into the side of the filter (at a pressure of 87 psi at the most). Safety glasses required
4. Reinstall the filters and the rear hopper.
11