CB Tech WaterBox Manual de operação - Página 14
Procurar online ou descarregar pdf Manual de operação para Sistemas de filtragem de água CB Tech WaterBox. CB Tech WaterBox 20 páginas. Mobile water filtration system
Imprimir página When the vertical distance between the source water and the WaterBox™ is greater
than 8', such as a well or steep embankment, it may be required to prime the intake
line. A one-way valve attachment is supplied to allow priming from water sources
with a vertical distance up to 20 feet. One to two gallons of water at ground level are
needed for priming.
Procedure:
1. Disconnect intake attachment from the intake hose.
2. Attach one-way valve assembly to the female fitting of the 25' intake hose.
3. Attach the intake assembly to the one-way valve assembly.
4. Attach the male end of the intake line to the WaterBox™.
5. Place the intake line into the supplied water at ground level.
6. Turn on the WaterBox™, press the pressure relief valve on the first Stage I filter
housing to purge the air, and allow the line to be primed. All air must be purged
from the line including the internal lines connected to the pump.
7. Turn off the WaterBox™ once lines are primed.
8. Lower intake end of line into source water.
9. Turn on the WaterBox™ and operate normally.
D. Maintaining the CB Tech WaterBox™
NOTE: CB Tech Nanomesh™ Stage I and II
filters must always be used when operating
the CB Tech WaterBox™. Operation of the
system without a CB Tech Nanomesh™ Stage I
or a Stage II filter, voids the stated filtration
performance claims.
Changing the Filter Cartridges
1. Position the CB Tech WaterBox™ in normal
operating position with the carrying handle
at the top and its cover open. It may be
desirable to place it on an elevated surface
to facilitate cartridge(s) installation.
Figure 8: One-way valve attachment.
Page 14 of 20