CBA RA-4961-MCQ Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Acessórios CBA RA-4961-MCQ. CBA RA-4961-MCQ 4 páginas. Wireless magnetic contact

Imprimir página

CBA Wireless Magnetic Contact

Installing Batteries:

1. Slide the cover from the battery compartment on

the front of the contact.

2. Place 2x CR2032 batteries (included) in the

battery compartment, making sure to observe

correct polarity.

3. Replace the cover.

Note: Low battery is indicated on the receiver. Refer to the RA-4961-K1Q or RA-4961-VPQ manual for more information.

Also Available from SECO-LARM:

Wireless

Outdoor PIR Sensor

RA-4961-DSQ

FCC COMPLIANCE STATEMENT:

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO

CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT

ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Notice:

The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority

to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change

to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the

RF exposure requirements and void user's authority to operate the device.

LIMITED WARRANTY:

used in normal service for one (1) year from the date of sale to the original customer. SECO-LARM's obligation is limited to

the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty

is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or

alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such

equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole

obligation of SECO

LARM and the purchaser's exclusive remedy, shall be limited to the replacement or repair only, at

SECO-LARM's option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential

personal or property damage of any kind to the purchaser or anyone else.

NOTICE:

The information and specifications printed in this manual are current at the time of publication. However, the

SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to

change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors. Trademarks

are the property of SECO-LARM USA Inc. or their respective owners.

in part, without the written permission of SECO-LARM.

SECO-LARM

16842 Millikan Avenue, Irvine, CA 92606

Phone: (949) 261-2999 | (800) 662-0800

Wireless

Alert System

Vibrating Receiver

RA-4961-K1Q

RA-4961-VPQ

This SECO-LARM product is warranted against defects in material and workmanship while

U.S.A., Inc.

Wireless

Pushbutton

RA-4961-PBQ

Website: www.seco-larm.com

Email: [email protected]

Wireless

Indoor PIR Sensor

Mailbox/Tilt Sensor

RA-4961-PRQ

RA-4961-MBQ

FCC ID: YAHHAX-100

MiRA-4961-MCQ_150914.doc

SECO-LARM U.S.A., Inc.

Wireless

PIHVK1