agri supply 59892 Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Compressor de ar agri supply 59892. agri supply 59892 16 páginas.

Closely follow instructions packaged with the filter for proper installation. It must be installed as close

as possible to the accessory.

The air compressor should be as near to air outlets as possible in order to avoid long pipe lines. Do

not place the air compressor where heat is excessive.

Do not use an extension cord. To avoid voltage drop and power loss to the motor, use extra air hose

instead of an extension cord.

Wiring Instructions

Perform electrical wiring according to the following instructions:

WARNING: Improper electrical grounding can result in a risk of electrical shock. Wiring for the

pressure switch AND electrical motor should be done by a licensed electrician in accordance

with national and local codes and ordinances.

Install the air compressor unit as close to the main power supply as possible. This practice will avoid

using long lengths of electrical wiring for the power supply which can cause power loss to the motor.

When connecting wires make sure that:

1. The amperage rating of the electrical box is adequate.

2. The supply line has the same electrical characteristics (voltage, cycle, and phase) as motor.

Refer to the Specification Chart or your air compressor unit.

NOTE: THESE UNITS DO NOT INCLUDE ANY WIRING BECAUSE OF VARIOUS INSTALLATION

REQUIREMENTS.

Voltage and Circuit Protection

Refer to the Specifications for the voltage and circuit protection requirements of your air

compressor. Use only a fuse or circuit breaker that is the same rating as the branch circuit

on which the air compressor is operated. If the air compressor is connected to a circuit

protected by fuses, use only dual element time delay fuses, as noted in the Specifications.

WARNING: This product should be connected to a grounded, metallic, permanent

wiring system, or an equipment-grounding terminal or lead on the product.

GROUNDING INSTRUCTIONS

WARNING: RISK OF ELECTRICAL SHOCK! In the event of a short circuit, grounding reduces

the risk of shock by providing an escape wire for the electric current. This air compressor

must be properly grounded.

DANGER: Improper grounding can result in electrical shock! All grounding should be

performed by a licensed electrician in accordance with national and local electrical codes!

Make certain that the electrical circuit to which the air compressor is connected provides proper

electrical grounding, correct voltage and adequate fuse protection.

The air compressor can be grounded by the following method:

When hard wiring an air compressor, use wiring that contains a bare copper grounding wire. This wire

must be connected to the pressure switch at the grounding location provided. This is located inside

the pressure switch. The other end of the wire must be connected to a ground at the fuse/circuit

breaker box in accordance with national and local electrical codes.

If these grounding instructions are not completely understood, or if you are in doubt as to whether the

air compressor is properly grounded, have the installation checked by an Authorized Warranty

Service Center or a licensed electrician.