Datapath Aetria WallControl VSN Series Manual de início rápido - Página 11
Procurar online ou descarregar pdf Manual de início rápido para Controlador Datapath Aetria WallControl VSN Series. Datapath Aetria WallControl VSN Series 17 páginas.
Imprimir página
Aetria WallControl Quick Start Guide
If you chose to have the DDCT configure your wiring, this page will display the recommended display
connections, as shown above. Connect each display to the corresponding output connector on the rear
of the VSN wall controller. The printed input/output diagram shipped with your VSN wall controller shows
where the display connectors are located on your system. If your VSN wall controller is connected to a
printer, you can print a copy of the wiring diagram using 'Print a Wiring Diagram' .
Note: The Datapath Diagnostic Suite must be installed to print a wiring diagram. The suite can be downloaded
from the Datapath website software downloads page should it not already be installed on your system.
To manually select the outputs right click on the display group and select 'Edit' . You can then select each
individual display and allocate your preferred output. Right click on a selected display to reveal the list of
outputs available:
When all outputs have been allocated by either Recommended or Custom click 'Finish' . You will then be
prompted to save the changes to your video wall and restart your system. When restarted, the Windows
Desktop will be displayed across the wall.
You can access the configuration tool at any time should you wish to make changes. Right click on the
desktop and select 'Display Driver Configuration Tool' from the menu.
1 1