DUUN PA20 Manual de instruções - Página 5
Procurar online ou descarregar pdf Manual de instruções para Equipamento industrial DUUN PA20. DUUN PA20 13 páginas.
Power transmission shaft
The tractor is disengaged and the handbrake is applied
before the shaft is connected to the tractor's PTO. Max.
PTO speed is 540 r.p.m. Make sure that there is the same
angle in both joints (ie the pin on the tractor is parallel to the
pin on the gearbox). Different angles cause imbalance,
vibrations and increased wear. The power transmission
shafts must always have protective covers that were
originally supplied. Damaged and worn covers must be
replaced immediately!
During raising and lowering of the rod pump, the power
transmission shaft is dismantled.
Safety in case of interruptions and maintenance
Always remember to stop the tractor engine and remove the
ignition key before greasing, adjusting, cleaning or carrying
out repairs. This is to ensure that the tractor does not start
before you have finished.
Crushing hazard for hands and fingers with rotating
parts
Protective covers must always be fitted except for necessary
maintenance and always with the engine stopped. Pay
particular attention to the risk of crushing at points marked for
this.
Work noise
The noise level during use of the propeller depends on the
tractor's general noise level and the acoustics at the
workplace itself. In certain cases this can exceed 85db. In
such cases, the operator must use hearing protection.
Gas hazard!
During the stirring of slurry, gas evolution occurs which in
strong concentrations can be fatal for humans and
animals. Follow the following safety regulations to avoid
injury! - Avoid air flushing during stirring as far as
possible!- Never go down into a slurry container without
being absolutely sure that all gas has been removed (can
be checked with a gas meter that is submerged with a
string) - Never work alone in a slurry container - be at least
two people and use a safety harness - lifeline. - Use a
fresh air mask! -open doors that the gas has low outlets in
the farm building itself during slurry processing.
Check the state of health in the farm building continuously
during slurry handling!
Avoid any unnecessary stay near the slurry chute and
propeller during stirring.
5