Datapath ALIGO QTX100 Manual de início rápido - Página 4
Procurar online ou descarregar pdf Manual de início rápido para Recetor Datapath ALIGO QTX100. Datapath ALIGO QTX100 12 páginas.
Também para Datapath ALIGO QTX100: Manual de início rápido (7 páginas)
Imprimir páginaAligo Quick Start Guide
HOW TO CONNECT THE ALIGO QTX100, ALIGO TX100 AND ALIGO RX100
Connect the Aligo QTX100 or AligoTX100 to a mains power supply.
Connect up to four graphic outputs from your video sources to the HDMI input connectors on the
rear of the Aligo QTX100 or Aligo TX100. Note: Where only one input is required, then input 1 must
be used first before using inputs 2-4. Input 1 must always be connected to a valid HDMI source in
order to function correctly, and you can only use inputs 2, 3 or 4 when using input 1.
Connect SFP+ transceiver modules into the 10Gb SFP+ cages on the Aligo QTX100 or Aligo TX100.
There are four 10Gb ports on the Aligo QTX100 and one 10Gb port on the Aligo TX100.
(See illustrations).
Connect an OM3 (minimum) fiber cable into each SFP+ module and connect the other end to
the network switch using another SFP+ module at the switch end. We recommend using the
same manufacturer model and grade of SFP+ module at both ends of the link. Note: An SFP+
module and 10Gb network connection is required for each HDMI channel i.e. if all four HDMI
inputs are used, then all four network connections must be connected.
Ensure that the switch port chosen has been configured to use the same Local Area Network (LAN/
VLAN) as the active Aetria Network Manager server (see Aetria Network Manager Quick Start Guide
for more information).
Now connect an Aligo RX100 into a spare switch port which has also been configured onto
the same LAN/VLAN as the Aligo QTX100 or Aligo TX100 devices and the active Aetria Network
Manager server. Connect the Aligo RX100 using the 10Gb SFP+ port located on the rear panel.
Connect the Aligo RX100 HDMI output ports to the display devices. Note: Where only one output
display is required, then output 1 must be used first before using outputs 2-4. Output 1 must always
be connected to a valid HDMI sink in order to function correctly, and you can only use outputs 2, 3
or 4 when using output 1.
Repeat as necessary for all Aligo devices required in the system, connecting all endpoints to the
switch, or switches such that they appear on the same Local Area Network.
Where KVM functionality will be required, connect the USB Type-B ports on the Aligo QTX100 or
Aligo TX100 into spare USB ports on the source PC's that you wish to control. For more information
on how to configure OneControl KVM feature please see separate Aetria documentation.
When connecting USB and HDMI ports to the source PC's for KVM control, care should be taken
to ensure that each USB channel matches its relative video channel in each case. i.e. USB1 should
connect to the same source as HDMI1 video, USB4 to HDMI4 etc.
4