Datapath VSN870-RPSU Manual de início rápido - Página 6

Procurar online ou descarregar pdf Manual de início rápido para Ambiente de trabalho Datapath VSN870-RPSU. Datapath VSN870-RPSU 14 páginas.

Step 3

Getting Started

Connect the USB Keyboard, Mouse and Wall Control software USB Key (unless fitted internally on

request) into vacant USB connectors located on the SBC Backplane.

(Fig.3 -

S2)

Connect the Power Cable(s) to the chassis

(Fig.3 -

P1). Failure to connect both power cables on an RPSU

system will result in an audible alarm and a red power LED is displayed when the system is switched on.

How to Connect Output Screens

You should exercise great care when connecting all cables to the connectors.

If the pins are oriented correctly and the connector is pushed on squarely, the use of force is not re-

quired. Poor handling may cause some pins to bend within the plug on the cable and this, in turn will

cause damage to the output socket and in some instances will cause irreparable damage to the Printed

Circuit Board.

Such damage is not covered under warranty

Control Screen

A Control Screen is a stand alone VGA output screen separate from the display wall. The system is

configured to boot up on the Control Screen. The Control Screen is configured as the Primary Monitor in

Windows® with the display wall as the Secondary Monitor, unless previously requested.

Connect your Control Screen to the VGA output of the SBC using an analog VGA Cable.

(Fig.3 -

S4)

Display Wall

Connect the monitors of the display wall to the output connectors

(Fig.3 –

1-2) using the DVI or RGB

output cables provided.

Fig.4