Dux Proflo 50S124P Manual do Proprietário - Página 10
Procurar online ou descarregar pdf Manual do Proprietário para Aquecedor de água Dux Proflo 50S124P. Dux Proflo 50S124P 16 páginas. 25l and 50l electric storage water heater
Também para Dux Proflo 50S124P: Manual do Proprietário (16 páginas)
Imprimir página
General:
This water heater is designed for single
phase 240V a.c. supply only. The electrical
connection must comply with Local Supply
Authority Regulations and AS/NZS 3000.
Pre-Wired Models:
Water heaters with the letter "P" at the end
of their model number are factory fitted with
a power supply cord. These water heaters
may be plugged into a standard general
purpose power outlet.
If the power supply cord is damaged, it must
be replaced by the manufacturer, a service
agent or a similarly qualified person in order
to avoid a hazard.
"Hard Wired" Models:
Water heaters without the letter "P" at the
end of their model number are not factory
fitted with a power cord.
Connection of the electrical wiring must only
be carried out by a licensed tradesperson.
Before removing the electrical cover, ensure
the electrical power supply is safely isolated.
Connections are made at the terminal
block under the water heater electrical
cover, and a means for disconnection
must be incorporated in the fixed wiring in
accordance with the Wiring Rules.
6
Owner's Manual – Proflo 25/50 Litre Water Heater
Electrical Connection
The electrical cover may be removed by
undoing the two screws at the bottom of the
cover and sliding the cover downwards to
disengage the top edge.
Cable entry to the connection area is through
the hole in the case beneath the electrical
cover, designed to accept a 20mm conduit.
Ensure the conduit entry is well sealed to
achieve the correct weatherproofing.
When the supply wiring has been connected,
ensure the wires are kept lower than the
terminal block.
Before replacing the electrical cover, press
the reset button on the thermostat to ensure
the over-temperature energy cut-out is set.
Ensure the water heater is filled with
water before turning on the electricity
supply.
028299
Rev. B