4ms Company Dual Looping Delay Notas de lançamento - Página 9
Procurar online ou descarregar pdf Notas de lançamento para Equipamento de gravação 4ms Company Dual Looping Delay. 4ms Company Dual Looping Delay 10 páginas.
Também para 4ms Company Dual Looping Delay: Manual do utilizador (20 páginas)
Imprimir página
System Settings: The 'Up-Center' Group (Version 4 legacy)
Auto Muting
Auto Mute is a noise gate that silences the input when a signal less than 5mVpp is detected on any input. This
prevents runaway feedback if Feedback is turned up and the DLD is allowed to run for a long time with no input
signal. In most cases, it is not necessary to turn off the Auto-mute, since a 5mVpp signal is extremely quiet.
Delay Feed CV Assignment
Mix CV, when enabled, re-assigns the Delay Feed CV jack to control the Mix (Dry/Wet) amount
Soft-Clipping
Soft Clipping enables limiting (compression) when the output signal exceeds 75% of the clipping point. Below this
point, the signal is unaffected. This saturation distortion sounds is often more pleasing to hear versus harsh clipping.
In most cases, it is not necessary to disable soft clipping.
System Settings: The 'Up-Down' Group (Version 4 legacy)
Loop and Main Clock Output Duty Cycle
The clock output jacks can output gates or triggers (22ms pulse width). In this mode, the loop lights and Ping light will
each blink once in sequence. A short flicker means the associated jack is in trigger mode, and a longer blink means it's
in gate mode. The associated button will also be lit to indicate gate mode, or unlit to indicate trigger mode.
LED Brightness Control
The red and blue Loop LEDs can be dimmed: Hold Infinite Hold B while turning the Feedback A knob (In
firmware v3 and earlier, it's not necessary to press Infinite Hold B)