Friendship Lamps 208077 Manual - Página 2
Procurar online ou descarregar pdf Manual para Luz exterior Friendship Lamps 208077. Friendship Lamps 208077 2 páginas.
Imprimir páginaSet-up instructions
Get ready!
Please make sure you have your GroupID handy. You
can generate one here: friendlamps.com/groupid
The same GroupID must be used for all the lamps on
your network. Please do not set up the lamps
without a GroupID.
Turn it on!
Connect the lamp to a USB charger or laptop with
the provided USB cable. The lamp will turn blue, and
then after a few seconds it will turn red.
Find the Friendship Lamp Wi-Fi
When lamp is red, connect to the new Wi-Fi network
named "FriendLamp_xxxxx" with a computer or
mobile phone. You will temporarily be disconnected
from your home Wi-Fi.
Select "Configure Wi-Fi"
Once connected to the Wi-Fi, there will be a popup
asking you to sign into the Wi-Fi. Press the popup and
it will take you to the sign in page.
If there is no popup, please open a web browser on
the connected device and enter the following into the
address field "192.168.4.1", this will take you to the
same page.
Connect the lamp to your home Wi-Fi
If your network does not appear, please press the scan
link at the bottom of the page.
Select your Wi-Fi network and enter your Wi-Fi
password and your GroupID.
Friendship
Lamp
Explanation
Functions
With a single touch you can contact all the other
Contact
lamps on your GroupID. It will pulse for about 30
other lamps
seconds then slowly dim over time.
When you hold your finger on the touch button,
the lamp will turn on, then off, then start cycling
Change
through the available colors. Just hold down until
you see the color you want and then let go. The
color
lamp will swirl the new color then turn off. Tap
again to send the color.
If for any reason you would like to stop the lamp
shining, you can simply hold down the button for
Turn lamp
three seconds, releasing when the lamp is off. If
off
your friend touches their Friendship Lamp your
lamp will turn on again, so you do not have to
worry about missing a message.
Although you will most likely not need to do this,
you can re-enter the Wi-Fi configuration mode
by holding down on the button for about 30
Change
seconds. You will notice the lamp cycles through all
GroupID
the colors several times, but eventually it will settle
or
on dim red. At this point you can connect to the
Wi-Fi
Friendship Lamp's Wi-Fi and change the Wi-Fi
settings
settings or the GroupID. This may be useful if you
want to make sure the lamps are on the same
network if they are not working properly.