DataStor Compaq Proliant Ultra2 SCA Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Armazenamento DataStor Compaq Proliant Ultra2 SCA. DataStor Compaq Proliant Ultra2 SCA 2 páginas. 80pin hot plug tray

Imprimir página

Installation Guide

Compaq

Proliant

Packing List - Check Contents Prior To Installation:

1) 1 - SCA 80 pin Hot Plug Tray

2) 1 - 1.6" Tray Cover Grill

3) 1 - 1.0" Tray Cover Grill

4) 1 - Screw Pack

Electrostatic Discharge

Many components on your hard disk are susceptible

to electrostatic discharge. To prevent damage to these

components, take careful precautions before handling

your hard disk.

Compatibility Disclaimer

NOTE: This Hot Plug tray is only compatible with the

following models of Compaq

3000, 1600, 6000, 6500, 7000, 5500, 1600R,

1850R, 2500, 6200H, 1200, 850R

NOTE: Drives used with this Hot Plug tray should

be verified as compatible with one of the above

server models prior to attempting installation.

Drive Termination Warning

NOTE: You MUST disable any automatic or

passive drive termination features on your hard

drive prior to using a drive in this tray.

Remove Cover Grill from Tray

1. This kit comes with two cover grills for the tray,

a 1" Low Profile cover, and a 1.6" Full Height

cover. Remove whichever of these two

covers is attached to the tray by sliding the

cover back and then lifting it up and away from

the tray.

Install Drive into Tray

1. Make sure your drive is oriented correctly on

the tray so that the SCA 80pin connector side

of the drive is pointed toward the Rear of the

Tray. (Figure 2).

2. Fasten the drive to the bottom of the tray via

the four mounting holes (Figure 2).

(MORE)

Installation Guide - Hot Plug Tray, Ultra2 SCA 80pin, Compaq Proliant , Rev 1.0 - August 1999 - P/N CQPTSCA

Ultra2 SCA 80pin Hot Plug Tray

Proliant

Compaq

and Proliant

are both Trade Marks of Compaq Computer Corporation.

Figure 1

Figure 2

SCA 80pin

Connector

Power, Activity,

and Error LED's

Rear of Tray

(Connector)

Drive Mount

Holes

Tray

Release Levers

Tray

Cover

Slots

(Both

Sides)