DVA ISI 5 Características técnicas - Página 3

Procurar online ou descarregar pdf Características técnicas para Dispensador de água DVA ISI 5. DVA ISI 5 4 páginas. Automatic water softener

CHOOSING THE PLACE OF INSTALLATION:

Waste water resulting from the regeneration must be

funneled into the floor sink by the flexible pipe.

If the floor sink is placed higher than the water

softener, the maximum height acceptable is 1.8

metres, provided that the pipe is not longer than 5

metres and the pressure of the water system is at least

2.8 bar.

If the water softener is near a boiler, check that the

pipes and the water softener itself are not subjected to

overheating. If possible, install a pipe that keeps a few

meters' distance (at least 3) between the outlet of the

water softener and the inlet of the boiler.

Keep away from corrosive or acid products.

CONNECTION TO THE DRAIN SYSTEM (A).

The drain pipe is not flattened or bent, as water should

flow without impedements.

THE OVERFILL PROTECTION PIPE (B)

Insert flexible pipe in the quick joint, then connect the

pipe to a floor sink that must be placed under the quick

joint, because the water that may come out will not be

pressurized.

MAINTENANCE FOR THE INSTALLER:

For the equipment to work in optimal conditions, we

suggest

performing

the

following

operations

periodically: Clean the injector (B), its filter (A) and the

brine control (C). Make sure that the quick couplings

(D) have a perfect seal.