Aussie 6T01U00SS1 Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para grelha Aussie 6T01U00SS1. Aussie 6T01U00SS1 20 páginas. Table top grill

How to Perform A Leak Test - "FIRST TIME USE"

and as recommended on previous page

Supplies Needed for a Leak Test:

• Clean paint brush • Water • Dish washing liquid • Empty clean bowl or can for solution

1. Make sure the regulator knob is turned to the "Off" position and verify that the LP Gas Cylinder is tightened

securely to the regulator.

2. Mix one part of water with one part of dish washing liquid.

3. Brush mix on Regulator, Propane Cylinder and connection as indicated by the heavy arrows in the figure below

. If "growing" bubbles appear, there is a gas leak.

a. If leak appears at the regulator/cylinder connection, repeat cylinder installation procedure, but do not over-

tighten. (NOTE: Only hand tighten) Repeat Leak Test.

b. If the leak is coming from the Gas Cylinder or if the leak cannot be stopped, remove the cylinder and DO NOT

USE THE GRILL. Call Customer Service at 1-800-251-7558. Be sure to have the grill model number and

serial number printed on the label, located on the inside of the rear leg. If you need a replacement part

under warranty, a proof of purchase will be necessary.