Aussie Monsoon 100 Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Máquina de lavar roupa de pressão Aussie Monsoon 100. Aussie Monsoon 100 16 páginas. Monsoon series

Imprimir página

March 2018

Hose Connections

1. Connect high pressure hose to machine outlet.

2. If optional low pressure downstream, in-line

chemical injector is to be used, connect the

injector tube to the detergent inlet and place the

other end of the tube, with the strainer attached, in

the chemical container (not supplied).

3. Connect gun/lance assembly to high pressure

hose.

4. Check inlet water filter is clean then connect water

supply hose to machine. Use a 25mm (minimum)

hose .

Incoming water supply must deliver double the flow of

the machine. If questionable, check supply at

machine. If supply is insufficient, do not operate from

this outlet. For residential use, the outlet closest to the

meter will usually deliver the highest flow rate.

Connect only to clean town water supply.

Warning: Do not operate from tank or pond.

Doing so will cavitate the pump causing damage.

Cavitation or pump starvation is not covered by

warranty. Cavitation is a phenomenon causing

vacuum pockets to form within the pump that

eventually implode under pressure pitting the internal

pump surfaces.

Aussie Safety Protection Kit

Inlet filter

Thermal dump

Aussie Monsoon Single Phase Blasters ... Operation & Maintenance Manual

Unloader -

factory set,

DO NOT adjust

Detergent

injector

HP hose

connection

Supply hose connection

HIGH PRESSURE SPRAY CAN PENETRATE THE

SKIN AND CAUSE SERIOUS INJURY!

NEVER POINT THE SPRAY GUN AT YOURSELF,

OTHER PEOPLE OR ANIMALS.

SHOULD SPRAY PENETRATE THE SKIN, SEEK

MEDICAL ATTENTION IMMEDIATELY!

Fitting Instructions for Optional Hose Reel

(Part number AD300001)

Fit hose reel to the mounting bar using the four



sets of nuts and bolts supplied. Ensure all bolts

are securely tightened and use Loctite to prevent

them vibrating loose.

The reel should be positioned so that it rotates

fore/aft to aid fitting whip hose.

Connect whip hose to high pressure outlet on



pump.

Fit handle to reel.



Fit gun to hose using C1500.180 nipple.



Start up machine (see below) and check for leaks.

All leaks must be rectified before using machine.

UNLOADER SETTING

The high pressure unloader on the machine is

factory set to operate the pump at it's rated

pressure.

DO NOT ADJUST. Tampering with the unloader

will void warranty and can be dangerous.

Aussie Pumps