Datatool EVO PRO Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Acessórios para motociclos Datatool EVO PRO. Datatool EVO PRO 9 páginas.
Também para Datatool EVO PRO: Manual do utilizador (5 páginas)
Imprimir página9.0 - PAIRING NEW DEVICES
9.1 - With BROWN/GREEN wire ground connection
The alarm is supplied with 2 remote controls and 1 override key but other
optional devices can be added.
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automatically delete the first one.
To pair a new device, proceed as follows:
Make sure passive immobilisation is not active.
!
Arm and then disarm the alarm via remote control or override key.
!
Lift the seat or open the topcase or, if there is no contact switch, ground the
!
BROWN-GREEN wire.
Connect the WHITE-VIOLET wire to ground.
!
Turn ignition key to ON.
!
Two flashes of the turn indicators, a Beep and a Bop will confirm the system
!
is in learn mode.
Remove the WHITE-VIOLET wire from ground.
!
Depending on which device is to be paired either press one of the remote
!
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the infrared
sensor or wireless hyper-frequency sensor transmit (refer to sensor
instructions).
A flash of the turn indicators and a Beep will confirm the operation has been
!
completed successfully.
To pair another device, ground the WHITE-VIOLET wire for 1 sec.
!
To exit learn mode, turn ignition key OFF.
!
A Bop and a flash of the turn indicators will confirm the end of the procedure.
!
Close the seat/topcase or remove the BROWN/GREEN wire from ground.
!
PAGE12
9.2 - Without BROWN/GREEN wire ground connection
To pair a new device, proceed as follows:
Make sure passive immobilisation is not active.
!
Arm and then disarm the alarm via remote control or override key.
!
Turn ignition key to ON
!
The status LED will turn ON for 1 sec.;
!
While the LED is ON, simultaneously press both buttons on the remote
!
control or touch the override key to its receptacle.
Two flashes of the turn indicators, a Beep and a Bop will confirm the
!
system is in learn mode.
Depending on which device is to be paired either press one of the remote
!
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the
infrared sensor
or
wireless hyper-frequency
sensor instructions .
)
If another device needs to be paired, wait 2 sec. before doing so.
!
To exit learn mode , turn ignition key OFF.
!
A Bop and
a flash of the
turn
indicators
!
procedure.
.
sensor
transmit (refer to
will confirm the end of the
PAGE13