Aussie Pumps Eco-Clean TTK 2130 HYD Manual de instruções do operador - Página 9

Procurar online ou descarregar pdf Manual de instruções do operador para Bomba de água Aussie Pumps Eco-Clean TTK 2130 HYD. Aussie Pumps Eco-Clean TTK 2130 HYD 16 páginas. Hydraulic drive high pressure blaster

Sept 2018

WATER SUPPLY HOSE:

Use a good quality supply hose (not supplied) of 19mm
diameter minimum on TTL & TTK versions, 25mm on
RAL version.
Fasten the one end of the hose to the inlet hose
connector securing using a worm drive clamp. This
connection MUST be tight to avoid leaks. (19mm hose
tail provided TTL & TTK versions, 25mm hose tail on
RAL version. )
Water supply can be by means of either:
$
Mains Supply
Secure the free end of the hose to your tap using a
suitable tap adaptor (not supplied - available
through all good hardware and garden supply
stores).
$
Syphon Fed Supply
Place the free end of the hose into a water tank or
container and the pump will draw water itself.
Use a larger diameter suction hose, at least 3/4"
diameter and no more than 2 metres long. Water
supply must be above or level with pump.
NOTE: The unit is fitted with a Y strainer inlet filter.
Ensure this is removed and rinsed to clear debris
before each use.

OPERATION:

Turn on water supply if applicable. Note: Tap
should be full on.
Pull the trigger to expel air from the system.
Water will trickle from the end of the lance
when air is expelled.
Engage hydraulic to power to blaster.
Check that there are no leaks in the line
connections, gun or power lance. Pressure
begins when the pistol trigger is squeezed.
Aussie Hydraulic Drive Blaster ... Operation & Maintenance Manual
SHUT DOWN
Turn off water supply if applicable.
Disengage hydraulic to power to blaster.
Pull the trigger release pressure from the
system. Gun trigger should be locked to prevent
accidental activation.
Hose and gun/lance assembly can now be
stowed or detached.
NOTE:
Failure
to
disconnecting the hose quick coupler will result in the
quick coupler o-ring seal blowing out. This o-ring
must be replaced before operating machine.

ACCESSORIES:

(CONSULT AUSSIE BLASTER BLITZ FOR DETAILS)
Your Aussie water blaster can be used with a wide
variety of optional extras to enhance performance.
To use the accessories you must first disassemble the
lance. Unscrew quick coupler to unlock the lance.
The accessories can then be connected to the end of
the lance assembly. If quick coupler is not supplied it
can be purchased from your local Aussie Eco-Clean
Distributor.
TURBO LANCE -
duty turbo lance can cut pressure cleaning time
in half and is a very important accessory.
SANDBLAST HEAD - Wet grit-blasting is safe
and tremendously effective.
removal, paint stripping and graffiti removal.
OPTIONAL LANCES - A range of optional lances
in stainless steel or zinc plated steel are
available in lengths of up to 2 metres.
ROTARY CLEANER - The Aussie Eco-Clean rotary
cleaner allows flat surfaces to be cleaned in a
fraction of the time normally taken.
contractors and professional users.
release
pressure
before
A correctly selected heavy
Ideal for rust
Ideal for
9