Aussie Pumps D1310P4 Instruções de funcionamento e manutenção - Página 10

Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Máquina de lavar roupa de pressão Aussie Pumps D1310P4. Aussie Pumps D1310P4 20 páginas. Hot water pressure washer

Imprimir página

INTENDED USE

This appliance is intended exclusively for cleaning machines,

vehicles, buildings and general surfaces suitable for treatment

with a high pressure jet of detergent solution between 25 and

250 bar (360 - 3600 PSI).

This appliance has been designed for use with the detergents

supplied or recommended by the manufacturer. The use of

other detergents or chemicals may influence the safety of the

appliance.

This appliance must be used only for the purpose for which it

was specifically designed.

All other uses are to be considered incorrect and therefore

unreasonable.

Examples of unreasonable use:

Washing surfaces not suitable for cleaning with a high

pressure jet.

Washing people, animals, electric equipment or the machi-

ne itself.

Using unsuitable detergents or chemicals.

Blocking the trigger (lever) of the lance in delivery posi-

tion.

The manufacturer cannot be held responsible for any damage

due to improper, incorrect or unreasonable use. As far as safety

rules are concerned, the cleaners are manufactured according

to the European Standard.

PRELIMINARY OPERATIONS

UNPACKING

After unpacking, ensure that the cleaner is undamaged.

If in doubt, do not use the machine.

Contact your dealer.

Packaging (bags, boxes, nails, etc) is potentially dangerous and

should be kept out of reach of children. It should be disposed of

or retained in respect of national environmental legislation.

FITTING THE SEPARATE PARTS OF THE MACHINE

All the fundamental parts and safety devices of the machine are

assembled by the manufacturer.

For reasons of packing and transport, some secondary cleaner

parts are supplied separately.

The user must fit these parts as explained in the instructions

supplied in each assembly kit.

DATA PLATE:

The data plate bearing the main technical characteristics of your

cleaner is located on the trolley and is always visible.

When buying your cleaner, ensure that it has an

identification plate. If there is no plate, inform the manu-

facturer and/or the dealer immediately. Machines without

a plate must not be used and the manufacturer declines all

responsibility for them. Products without a plate must be

considered anonymous and potentially dangerous.

FILLING THE FUEL TANK

Fill the tank with fuel for Diesel

motors (fig. 1).

Warning

Do not use different fuel from that indicated on the

identification plate.

Check the fuel level from time to time while the

cleaner is operating.

Attempting to use the cleaner without fuel may cause

damage to the fuel pump.

FIG. 1