AUSSIE TONNEAU ATB01105 Instruções de montagem - Página 3
Procurar online ou descarregar pdf Instruções de montagem para Acessórios para automóveis AUSSIE TONNEAU ATB01105. AUSSIE TONNEAU ATB01105 3 páginas. Cover for mitsubishi triton mk dual cab with headboard
Imprimir página
3. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from
Suburu Brumbys to Cab Chassis aluminium trays.
3.1 BASIC TOOLS REQUIRED
-
Drill, 4mm drill bit
3.2 MULTI SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
3.3 FITTING MULTI-FIT SUPPORT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar
bracket holders with the holes facing to the ground (so the grub screws don't rub against
the tonneau), as shown above and then with a white pencil make a mark through the small
holes of the hollow bar onto the solid ends. This is where you will drill a hole to the depth
of about 1-2mm (do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes
that you drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may
kink the bar in the middle to give it some extra height to assist with water runoff.
-
2 x grub screws