AUSSIE TONNEAU ATB01123 Instruções de montagem
Procurar online ou descarregar pdf Instruções de montagem para Acessórios para automóveis AUSSIE TONNEAU ATB01123. AUSSIE TONNEAU ATB01123 3 páginas. Cover for toyota sr5
TONNEAU COVER FITTING INSTRUCTION
DUAL CAB WITH FACTORY SPORT BARS
TOOLS REQUARED
-
Rivet gun, Drill, 4.5mm Drill bit, Measuring tape, Silicon sealant, Anti-corrosive primer.
CONTENTS
1 x TONNEAU
1 x TONNEAU SUPPORT BAR
24 x RIVETS
4 x PIECES OF DOWELL
Some items in the fitting kit may not be needed. All fitting kits are weighed to ensure accurate quantities.
1. INSTALLATION PROCEDURE
Note: To prevent corrosion apply an anti-corrosive primer to all holes drilled
1. Using two pieces of dowel, join the 3 aluminium rope tracks together. Place the other 2 pieces of dowel in
the ends of the now joined rope track.
2. Rest the aluminium rope track on the side rails as Shown in Diagram A, and push forward to the vertical
face of the tub.
3. Using a 4.5 mm drill bit, drill 6 holes 50mm from the end of each of the aluminium rope tracks into the
front of tub.
4. Once all the holes have been drilled, remove the dowelling pieces. Squeeze silicon along the back of the
rope tracks and pop rivet into place.
5. To fit bar brackets measure 680 mm from the inside edge at the front of the tub and place them as shown
in Diagram A. (5mm down from top edge of tub). Drill and rivet using 4 rivets. Insert support bar.
6. To fit round body hooks to car measure 115 mm down from top edge and line up each hook individually to
each bunji (loop) starting with the two either side of the tail gate handle and working your way around to
the front, drill and rivet buttons alternating from side to side.
TOYOTA SR5 A DECK
2003 – MARCH 2005
PART NO: ATB01123
3 x ALUMINIUM STRIPS (484mm)
2 x BAR BRACKETS
14 x BUTTONS