Datavideo CCU-100J Manual de instruções - Página 16

Procurar online ou descarregar pdf Manual de instruções para Controlador Datavideo CCU-100J. Datavideo CCU-100J 20 páginas. Camera control unit

6.
HP-3 Connections & Controls
The HP-3 headsets are designed for the cameraman to communicate with the director. The HP-3 should be
connected to the 5-PIN XLR connector on the AD-2 (S/P/J). The Multi Transmission Adaptor Box (AD-2) then
transmits audio signals to and from the ITC-100 Intercom System via the CCU-100 Camera Control Unit.
6.1

Features

• Reference quality, closed ear monitors
• High suppression of ambient noise
• Soft, circumaural ear pad
• Noise cancelling microphone
• Condenser omni-directional microphone
capsule
• Very high gain-before-feedback
• Flexible gooseneck mic boom for optimal
positioning
Single exit, plug-in cable assembly
7.

Frequently-Asked Questions

This section describes problems that you may encounter while using PTC-120. If you have questions, please
refer to related sections and follow all the suggested solutions. If problem still exists, please contact your
distributor or the service center.
No.
Is there a defined system boot order for the
1.
CCU or any special care that needs to be
taken into account of?
The AD-2 handset does not issue side tone
2.
sound.
Problems
1. The recommended boot order is to turn on PD-6
first and then the rest of the devices.
2. Please make sure the 4-PIN XLR power cable is
the CCU proprietary cable, which is different from
the general XLR power cable.
3. It is recommended not to rewire the device
while the power is connected; any change of the
wiring should be done only after the power is
disconnected.
Please purchase AD-2 device of Version GB717-SL-
B or later.
- 16 -
Solutions