Frigidaire Designer Series Manual do Proprietário - Página 17

Avoid Service Checklist

Before you call for service, review this list. It may save you time and expense. The

list includes common occurrences that are not the result of defective workman-

ship or materials in this appliance.

This oven is equipped with an electronic oven controller. Among its many features

is a full time oven circuit diagnostics system. The controller constantly monitors

its internal circuitry as well as several crucial oven circuits, to insure they are all

operating correctly. If at any time one of these systems fail, the controller will

immediately shut down operation, and will beep and flash an error code of -F1-

through -F10- in the display window.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

Oven Control Beeps and Displays

-F1- through

-F10-,

Electronic control has detected a fault condition. Push the CANCEL pad to clear

the display and stop the display from beeping. Reprogram the oven. If a fault

reoccurs, record the fault number, push the CANCEL pad and contact an authorized

servicer.

Oven is not level.

Poor installation. Placea level on an oven rack in center of oven. Contact installing

agent if rack is not level; unit may be shimmed underneath.

Kitchen cabinet misalignment may make oven appear to be unlevel. Be sure cabinets

are square and level. Contact cabinet maker to correct problem.

Entire appliance

does not operate,

Make sure electrical cable is securely connected and grounded into electrical

circuit.

Service wiring not complete. Contact your dealer, installing agent or authorized

servicer.

Power outage. Check house lights to be sure. Contact your local electric

company.

Short in electrical cable. Contact your dealer, installing agent or authorized

servicer.

Electronic controls are not set properly. See instructions under Setting

Oven

Controls or Oven Cleaning.

House fuse has blown or circuit breaker has tripped immediately following

installation. House fuse may not be fully engaged. Check fuse or engage circuit

breaker securely.

House fuse has blown or circuit breaker has tripped after the oven has been installed

and previously operating. Call an authorized servicer.

Oven light does not work,

Burned out or loose bulb. Follow instructions under Oven Light to replace or

tighten the bulb.