Dw Drums DW 9300 Manual do Proprietário

Procurar online ou descarregar pdf Manual do Proprietário para Racks & Stands Dw Drums DW 9300. Dw Drums DW 9300 2 páginas. Snare drum stand

Imprimir página

DW 9300 SNARE DRUM STAND

Remove the stand and all packing materials from the box, then follow these instructions to set up and adjust your stand to fi t the way you play.

Section 1: Leg Assembly and Height Adjustments

Section 1.1: Leg Assembly

1. Loosen wingscrew on the clamp at top of base section.

2. Pull legs outward far enough to allow the clamp to contact memory lock.

3. Tighten wingscrew.

To open or close the legs, loosen the drumkey screw on the leg memory lock located on

the bottom tube section. Loosen the wingscrew on the clamp at top of base section and

adjust the tripod to achieve the desired position. Then tighten the clamp and memory

lock screw.

Section 1.2: Height

1. Loosen the memory locks and wingscrews on tube receivers.

2. Raise or lower the upper tubing section to the desired position.

3. Tighten memory locks and wingscrews on tube receivers.

Section 2: Snare Drum Basket Adjustments

Section 2.1: Snare Drum Basket

1. Loosen the TechLock™ drumkey screw and Position Reset handle on large basket

tilter.

Note: The Position Reset Handle is spring activated. To operate, grasp the handle with

your fi ngers and use your thumb to press on the button in the center of the handle

while pulling the handle away from the tilter. Reset the handle to a more comfortable

position and release.

2. Rotate the basket and positioning rod so that the basket is in its upright position

and tighten the Position Reset Handle.

3. Open the basket by rotating the large knurled knob at the bottom of the basket

clockwise several turns.

4. Place snare drum on basket so that it rests on the rubber grips.

5. Tighten the basket by turning the large knurled knob counterclockwise.

Note: Although a tighter basket will make your drum more secure it may also choke

the drum. Experiment to fi nd the best tightness for your situation.

6. Tighten the TechLock™ drumkey screw.

Section 2.2: Drum Positioning

By loosening the Position Reset Handles and TechLock™, the angle, rotation and offset

position of the 9300 can easily be adjusted.

a. Angle/Rotation - The basket can be tilted in any direction to achieve the most desir-

able position.

b. Distance Offset - The position of the Positioning Rod can be adjusted to allow for

an increased offset between the basket and the stand which makes the 9300 more

adaptable to the position of other stands, drums and pedals.

Section 2.3: Basket Removal

For easier pack up and more consistent set up, the 9300 features a removable basket.

To remove the basket from the stand, collapse the basket 1/2 way and loosen the two

drumkey screws that are located at the point where the basket is attached to the posi-

tioning rod. You can now remove the basket from the rod. This allows you to pack up the

stand while maintaining your position settings.

removable basket

universal position adjustment

Snare Basket

Basket Adjustment Knob

Upper Tube

Base Section

9300

Basket Removal Screw

Position Reset Handle

TechLock™

Positioning Rod

Instructions and parts identifi cations also apply to 9300L and 9303 stands.

Universal Angle Casting

Positioning Rod

Position Reset Handle

Tube Memory Lock

Tube Receiver

Leg Clamp

Leg Memory Lock

Legs