ADE Automatic Manual de instruções - Página 9
Procurar online ou descarregar pdf Manual de instruções para Utensílios de cozinha ADE Automatic. ADE Automatic 20 páginas. Gravity feed slicers with automatic transmission
Imprimir página
For mounting the sharpening device pull the carriage with carriage arm "B" in the maximum position to the
user and hinge up the remaining holder "C". Unscrew completely the black turning knob of the sharpening
device supplied with each machine with standard knife. Then lead the end of the thread visible now
through the hole of the thickness-plate from the side of the carriage, while pulling the last-slice-device a bit
upwards to the right. Then screw on the sharpening device by means of the turning knob in such a way
that the neck of the sharpening device rests upon the upper edge of the thickness plate.
5) Switch on the motor and advance the sharpening wheel carefully with not too much expenditure of force to
the rotating blade by turning slightly to the right the slice thickness adjusting knob. The contact must be
affected in such a way that the sharpening wheel is also turning. Normally a few seconds are sufficient to
sharpen the blade in this manner.
6) Having finished sharpening, switch off the motor, take off the sharpening device and adjust the slice
thickness to zero again.
7) Clear blade and shaft of the last-slice-device thoroughly of adhering sharpening shavings with a cloth.
The sharpening operation must be performed by skilled personnel.
Never attempt to clean the blade whilst it is moving.
The sharpening device can no longer sharpen the blade once its diameter is worn down by
6mm.
9.
TRAINING
During the machine's installation, it is absolutely essential that an operator of age be trained in the regular
use-cleaning-care -sharpening of the blade, especially regarding the hazards which are likely to be
encountered if the machine is used incorrectly. The training will be given by reading the operating manual
very carefully.
10. CLEANING AND MAINTENANCE
The machine must be cleaned by fully trained personnel only.
Unplug the machine. Never stop the machine using the red (stop) button only.
Two people are required to handle the machine, using the 4 feet as handholds.
The blade must be replaced when the distance between the blade guard and the actual blade is no more than
6mm.
Only remove the blade using the proper blade-removal tool.
Be careful with the blade edge as it is very sharp.
The power supply cable must be replaced by skilled personnel only.
The cleaning of the slicer with harmful products liable to affect the health of either operators
or customers is strictly prohibited.
Use products with a degree of acidity (pH 7-8).
Automatic_Automatic-Z-200626-Rev014-UM-en
8