ADE FL 82N Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Utensílios de cozinha ADE FL 82N. ADE FL 82N 20 páginas.

Reassembling the cutting set

Reassembly is done in reverse order.

First insert the worm housing (28). The

worm housing is fixed by turning the locking

lever (7) from top to bottom.

The worm (34) is inserted in such a way

that the stub shaft protrudes from the

machine to attach the knife and perforated

disc. Pushing it all the way back, the worm

shaft is rotated until it latches with its oval

pin at the rear end into the uniform slot of

the drive.

The perforated disc (39) is now pushed onto the stub shaft with the 3 large oval openings (pre-

cutter) and rotated so that the rectangular notch on the edge of the disc slides over the uniformly

shaped ridge of the worm housing (this also applies to the subsequent discs).

This is followed by the cross blade (40). Care has to be taken that the cutting edges point in the

forward direction of rotation.

Then, place the perforated disc (41) on the stub shaft.

This is followed by the second cross knife (40). Make sure that it is in the correct position again

(cutting edges point in the direction of rotation).

Then the second perforated disc (42) is added.

Then, place the spacer ring (6) in this way, that the nose of the spacer ring engages the notch of

the perforated disc (42) provided for this purpose.

The hand wheel (33) forms the end, which is first slightly tightened and then released by approx.

5°. (The latter is particularly important because the worm shaft must have some clearance in the

longitudinal direction for proper functioning of the mincer).

FL-200128-Rev007-UM-en

Now, the worm housing (28) is removed by simply pulling it

out. After turning the locking lever (7) above the switch

from bottom to top (clockwise), it can be removed forwards

(without tilting sideways).