Agri-Fab Lawn Care Made Easy 45-0554 Manual de instruções de montagem - Página 5
Procurar online ou descarregar pdf Manual de instruções de montagem para Carrinho de exterior Agri-Fab Lawn Care Made Easy 45-0554. Agri-Fab Lawn Care Made Easy 45-0554 10 páginas.
Imprimir página
aSSEMBLY INStrUCtIONS
tOOLS rEQUIrED FOr aSSEMBLY
(2) 10 mm Wrenches
(2) 13 mm Wrenches
(1) 20 mm Socket with Ratchet and Extension
(1) Needle Nose Pliers
(1) Grease Gun
Lay out and identify the parts and hardware using the
illustrations on page 3 and page 4.
IMPOrtaNt aSSEMBLY tIPS
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only. This will temporarily hold the
lock nut on the bolt while helping alignment of all parts.
After all parts are assembled together, all nut and bolt
combinations must be completely tightened.
Do initial assembly steps with the trailer frame parts
oriented upside down. This will aid in the assembly.
aSSEMBLE tHE traILEr FraME
StEP 1:
(SEE FIGUrE 1)
• Ensure the front trailer frame (1) and rear trailer frame
(2) are upside down.
• Secure the sides of the front trailer frame (1) to the
sides of the rear trailer frame (2) using two M6x50 mm
bolts (K), M6 steel washers (C), and M6 locknuts (F).
• Secure the bottom of the front trailer frame (1) to
the bottom of the rear trailer frame (2) using two
M6x65 mm bolts (J), M6 steel washers (C), and M6
locknuts (F).
1
2
C
J
K
C
F
FIGUrE 1
attaCH tHE aXLE MOUNtING PLatES
StEP 2:
(SEE FIGUrE 2)
• With the trailer assembly in the upside down position,
attach the top of the two axle mounting plates (4)
to the trailer frame assembly with four M6x40 mm
bolts (M), M6 steel washers (C), and M6 locknuts (F).
• Secure the bottoms of the two axle mounting plates (4)
using four M6x50 mm bolts (K), M6 steel washers (C),
and M6 locknuts (F).
4
K
M
aSSEMBLE tHE HItCH
StEP 3:
(SEE FIGUrE 3)
• Insert the rear tongue tube (7) into the "u-bracket"
on the axle tube (5) and secure with one M8x70 mm
bolt (H), M8 steel washer (B), and M8 locknut (E).
• Secure the latch tube assembly (10) to the top of the
rear tongue tube (7) with two M8x100 mm bolts (G),
M8 steel washers (B), and M8 locknuts (E).
• Insert the latch tube assembly (10) and the front
tongue tube (12) into the connector pocket (11)
and secure with two M8x60 mm bolts (I), M8 steel
washers (B), and M8 locknuts (E).
I
11
12
5
C
F
M
G
B
10
B
7
B
E
K
FIGUrE 2
H
5
E
FIGUrE 3