Cookshack PG500 Manual do operador - Página 6

Procurar online ou descarregar pdf Manual do operador para Fogões Cookshack PG500. Cookshack PG500 12 páginas. Fast eddy pellet cooker

 Insure the fire diffuser is in place over the fire pot and the drip tray is in the

proper position under the indirect cooking grill.

 Place the drain bucket on the retaining clip under the drain tube.

 Place both grills in their proper position and follow the operating instructions

listed below.

OPERATING INSTRUCTIONS

 During first firing turn switch on and set the temp to 400 degrees. The ignitor will

stay on until the cooker gets to 140 degrees. It will take several minutes to get

pellets to drop into the fire pot.

 Leave doors open during igniting. Close when you see flames from the fire pot.

 Manual lighting instructions (in the event there should be a failure with the auto

igniter.) Pour ½ cup pellets into the fire pot. Squirt approximately 2 tablespoons

of alcohol gel into the fire pot and ignite with a match. Never attempt to squirt

alcohol gel onto burning embers to further ignite. This has the potential of serious

injury. Let this burn for 4-5 minutes, turn on the switch and set the thermostat to

300 degrees.

 Your grill has an "LHt" (Low Heat Time) and an "HHt" (High Heat Time)

adjustment that allows you to make some adjustment to the ON time the auger

runs when above or below temp. This allows you to fine tune the operation of the

grill. These are set at a standard setting from the factory and we recommend

getting use to your grill before making adjustments. The unit comes preset at LHt

10 and HHt 100.

 Press and hold UP+DOWN for 5 seconds, display says "LHt". This is the "Low

Heat Time". This is the ON time when the temperature is above set point.

Release UP+DOWN to edit the value. Default is 3.5 sec which will register as 35

on the PG500.

 Press and hold UP+DOWN for 5 seconds, display says "LHt". CONTINUE

HOLDING UP+DOWN FOR ANOTHER 5 SECONDS, display says "HHt".

This is the "High Heat Time. This is the ON time when the temperature is below

set point. Release the UP+DOWN to edit the value. Default is 12 sec. which will

Fast Eddy's Model PG500