AUSTRALIAN MONITOR AMIS ZRM4 Informações sobre o serviço - Página 7
Procurar online ou descarregar pdf Informações sobre o serviço para Misturador de música AUSTRALIAN MONITOR AMIS ZRM4. AUSTRALIAN MONITOR AMIS ZRM4 20 páginas. 6 x 4 routing mixer
Também para AUSTRALIAN MONITOR AMIS ZRM4: Brochura (2 páginas)
Imprimir página
INTERNAL ADJUSTMENTS
1
2
1
HPF
When this switch is in the "HPF OUT"
position, the signal bypasses the high
pass filter. Otherwise the signal is filtered
by a high pass filter with a knee of
approximately 150Hz. This is useful in
removing "thumps", "pops" and "rumble"
when using the input with a lectern or
handheld microphone.
2
PHANTOM
15v phantom power is available for
condenser or electret microphones on the
XLR input when this switch is in the
"PHANTOM ON" position.
3
MIC / LINE
These two switches control the sensitivity
of the XLR input. In the "MIC" position the
XLR input is suitable for use with
microphones; in the "LINE" position the
XLR input is suitable for use with a
balanced line level signal.
NOTE: Both MIC/LINE
switches must be in the same
position for correct operation
of the balanced input. The
MIC/LINE switches only affect
the XLR input.
PAGE 6
3
4
4
GAIN TRIM
The input gain can be cut or boosted by
up to 15dB using this control. This control
affects both the XLR and the RCA inputs.
This allows a wide rage of program
sources to be set up with optimum gain
structure. With the gain trim in the centre
position, the boost/cut is set to 0dB.
See the block diagram on page 9 for
details of the gain structure.
5
TONES LEVEL
This controls the level of all the tones
generated by the tone module.
5
AMIS ZRM4 INSTALLATION & OPERATION MANUAL