AUSTRALIAN MONITOR MX82 Manual de instalação e operação - Página 6
Procurar online ou descarregar pdf Manual de instalação e operação para Misturador de música AUSTRALIAN MONITOR MX82. AUSTRALIAN MONITOR MX82 12 páginas. 8 channel stereo mic/line mixer
Imprimir página
I N T E R N A L A D J U S T M E N T S
1
2
3
5
P/P – PHANTOM POWER
1
15V phantom power is available for condenser or electret microphones on
the XLR input when this switch is in the "ON" position. This switch is
accessible through the lid of the MX82.
2
TONE TO DIRECT OUT
Signal from the optional tone generator can be removed from each direct
output via this switch. When in the ON position, the tones (when activated
from the optional tone module) are fed to the corresponding direct output
as well as the master Left/Right outputs. When the switch is set to the OFF
position, the tones are only present at the Master Left/Right outputs. This
switch is accessible through the lid of the MX82.
3
CHANNEL DIRECT OUT PRE/POST FADER
The pre or post assignment of the direct output is set via this jumper. This
is used to make the Direct Outputs either pre or post channel fader volume.
Set to the Channel 1 side the Direct Output is post fader (i.e. the channel
fader volume affects the Direct Output). Set to the Channel 8 side the Direct
Output is pre fader. The default factory setting is pre fader.
4
CHANNEL BUS SELECT ON/OFF MASTER OUTPUT
This jumper is provided for each of the fi rst 4 channels. The jumpers are
located near the front of the unit. When in the ON position (channel 1 side),
signal from that channel is fed to both the master outputs and the direct
outputs. When the switch is in the OFF position (channel 8 side), signal from
that channel is fed to the direct line level output only.
PA G E 6
4
7
5
CHANNEL 1 ROUTING
If channel 1 is being used as a priority input it can be routed so that the
master volume does not affect channel 1. The default factory setting is pre
master fader meaning the master volume affects channel 1 in the mix. The
jumper header is located above channel 1 pot. Move the jumper to link the
two pins nearer channel 8 to set channel 1 to post master fader.
6
HEADPHONE ROUTING
The headphone level can be routed so that it is affected by the master
volume. The default factory setting is pre master fader meaning the master
volume does not affect the headphone volume. The jumper header is
located just behind the front panel near the master pot. Move the jumper
to link the two pins nearer the inputs to set the headphone to post master
fader. Remember to set both the left and right channels.
7
OPTIONAL MODULES
The MX82 can have installed:
- 2 VCA modules for left and right outputs
- Tone Generator module
- 2 Priority Muting modules for left and right outputs
See your local Australian Monitor dealer for more information.
M X 8 2 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
7
7
6