Agri-Fab 45-0355 Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Leme Agri-Fab 45-0355. Agri-Fab 45-0355 8 páginas. 3 pt. hitch tang cultivator

Imprimir página
,
Attach the front of the weight
bracket
to the sup-
port bracket
using two 3/8" x 1" hex bolts and two
3/8"
Nylock
hex nuts.
Attach
the sides
of the
weight bracket
to the rear of the frame using two
3/8" x 2-1/4"
hex bolts and two 3/8" Nylock
hex
nuts. See figure 8.
9.
Tighten
all loose bolts and nuts at this time.
318" x 1" _'_
HEX BOLT
WEIGHT
318" x 2-114"
HEX BOLT
Ij
3/8" NYLOCK
HEX NUT
3/8" NYLOCK
HEX NUT
FIGURE 8
OPERATION
&
CAUTION:
USE CARE WHEN WORKING
AROUND A RAISED CULTIVATOR.
KEEP
YOUR FEET AND HANDS FROM UNDER
THE TANGS
AT ALL TIMES.
SERIOUS
INJURY
CAN
RESULT
SHOULD
THE
CULTIVATOR
DROP UNEXPECTEDLY.
.
To adjust the depth gauge bars, remove the nuts
from the U-bolt securing
each bar to the frame.
Then reposition
the U-bolt in another
set of holes
for the desired
depth of cultivation.
The bars can
be adjusted
up or down in 1" increments.
Be sure
to use the same matching
pairs of holes in each
depth gauge bar to ensure
the cultivator
is level.
Up to 160 Ibs. of weight
may be added
to help
increase
penetration.
40 lb. suitcase
weights
can
be attached
to the center weight bracket,
or con-
crete
blocks
or other
weights
may be tied
or
strapped
to the cultivator
frame.
Before
adding
weight,
the cultivator
should
be attached
to the
tow vehicle
and lowered
to the ground.
ADJUST
DEPTH
GAUGE
BARS UP
OR DOWN AS
REQUIRED
TO
CHANGE
DEPTH
OF CULTIVATION
The tine cultivator
is used to loosen
soil and other
types of landscape
material.
1 ,
Before
starting,
make
sure
the material
to be
cultivated,
such as dirt, is dry enough
by squeez-
ing some in your hand. If it forms a ball that doesn't
crumble,
the material
may be too wet to cultivate.
2,
The cultivator
can be set for various
depths
of
cultivation.
To change
the cultivation
depth, raise
or lower the two depth gauge bars located on the
back of the frame assembly
as shown in figure
9.
FIGURE 9
MAINTENANCE
1.
Check for and tighten any loose hardware
before
each use.
2.
Clean the cultivator
and lightly oil only bare metal
after each use.
3.
Remove
all dirt and rust. Touch
up paint before
placing
cultivator
in storage.
4.
Store cultivator
inside a dry area.