AFC KPO-001 Instruções de montagem e funcionamento
Procurar online ou descarregar pdf Instruções de montagem e funcionamento para Utensílios de cozinha AFC KPO-001. AFC KPO-001 3 páginas. Original kettlepizza oven
Imprimir páginaAssembly & Operating Instructions
KPO-001 Rev1
Thank you for purchasing the Original KettlePizza
Oven! Cooking pizza with this product can be a great
and fun family activity. As with all charcoal grills there
can be some risks involved. Please read the following
safety warnings and keep them in mind at all times.
Safety Warning:
You should always exercise reasonable care when
•
operating your KettlePizza Oven.
The KettlePizza Oven will be hot during and after
•
cooking and should never be left unattended while
in use.
Never leave children, infants or pets unattended
•
near a hot KettlePizza Oven.
Only use outdoors in areas with adequate
•
ventilation.
Keep away from combustible materials.
•
Never remove ashes until charcoal is completely
•
burned out.
Access to a fire extinguisher whenever using a
•
charcoal grill is recommended.
Do not use in high winds and do not wear loose
•
clothing that can catch fire while operating the
KettlePizza Oven.
Assembly Instructions:
1. Remove all items from box. Be careful when removing
the black sheet metal body because it may expand without
the restraint of the box. Note that the pizza pan is under a
piece of cardboard in the bottom of the box.
KettlePizza.com is an affiliate of
AFC Business Ventures
The Original KettlePizza Oven
2. Form the pizza oven ring by taking the two 2-inch bolts
and placing them through the rear holes as shown below
(DO NOT remove the hex nuts from the bolts). Place the
lock washer and the wing nut on each bold on the inside of
the ring and hand tighten. Try to align the wing nuts
horizontally if possible.
3. Attach the two handles to the pizza oven ring as shown
on next page (DO NOT remove the hex nuts from the
bolts). Again, place lock washer and the wing nut go on
each bolt on the inside of the ring and hand tighten. Try to
align the wing nuts horizontally if possible.
Patent Pending
Page 1