CookTek SinAqua IHW062-64 Manual de instalação, operação e do proprietário - Página 10
Procurar online ou descarregar pdf Manual de instalação, operação e do proprietário para Utensílios de cozinha CookTek SinAqua IHW062-64. CookTek SinAqua IHW062-64 11 páginas. Induction holding well
Imprimir página
TROUBLESHOOTING
Symptom
Error Cause
No power (no
• Unit unplugged.
lights or fan
• No power to
noise.)
receptacle.
Pan does not
• Pan is not induction
heat.
efficient.
• Pan not centered.
Dry well
• Possible power brown
suddenly stops
out.
heating.
• Circuit shared with
another electrical
device.
• Safety shut-off
engaged.
Pan does not
• Extension cord in use.
get hot enough
• Circuit shared with
even though
another electrical
power levels are
device.
set to maximum
– induction
efficient pan in
use.
Pan heats
• Pan is not induction
unevenly, does
efficient.
not maintain
• Pan bottom may not
heat level, or
be flat enough.
overheats.
• Pan not centered.
• Pan diameter is less
than 7" (178 mm).
Displayed Message
• Plug unit into appropriate receptacle
• Make sure that receptacle is
energized.
• Check wall switches.
• Check circuit breaker.
• Plug a different electronic device
into the receptacle to make sure
that power is present.
• Use induction efficient pan.
• Center pan.
• Assure proper voltage/power levels.
• Make sure the dry well is not
sharing a circuit with electrical
devices other than CookTek holding
well units.
• The safety shut-off will engage if
an empty pan is left on the holding
well surface while the unit is working
at full power. Make sure that the
holding well surface is clear. Wait
15-20 minutes for the unit to reset.
• DO NOT use extension cords.
Extension cords may affect
the power levels reaching the
appliance.
• Make sure that the holding well
is not sharing a circuit with other
electrical devices.
• Use induction efficient pan.
• Use flatter pan.
• Center pan.
• Use a larger induction efficient pan.
9
ERROR CODES
In the event of a possible malfunction, your CookTek holding well will display an
error code on the alphanumeric display. Some models will beep a specific number of
times, indicated by the error and flash the lights on the control box. Please consult the
following table when encountering an error code. To reset error conditions, remove
the pan from the unit and press the Power button, or unplug the unit.
Error Error Cause
1
Broken temperature
sensor.
2
Broken temperature
sensor. Pan temperature
is too high.
3
Over current (peak).
6
High line voltage.
7
Hardware failure.
8
Zero cross error.
13
User interface error.
16
Critical error.
Displayed Message Troubleshooting
E-01
Service required.
E-02
Remove any pans from
the holding well surface
and let cool. Turn unit
off and on to reset error.
If problem persists,
contact service provider.
E-03
Try different cookware.
Service may be
required.
E-06
To reset, unplug unit,
wait 5 seconds, and
plug in again. If problem
persists, have an
electrician monitor the
line voltage.
E-07
Service required.
E-08
Turn unit off, then on.
Plug unit into outlet on
different circuit breaker.
If problem persists,
service is required on
device.
E-13
Check control panel
connection, cycle power.
Service required.
E-16
Call dealer for service.
Service required.
10