Austro Flamm FLOK 2.0 Instruções para o utilizador - Página 8

Procurar online ou descarregar pdf Instruções para o utilizador para Fogão a lenha Austro Flamm FLOK 2.0. Austro Flamm FLOK 2.0 20 páginas.

Imprimir página

Flok 2.0

Combustion air

Being the user of the stove you must take care of a

sufficient combustion air supply. Sealed-up windows and

doors may not allow a sufficient combustion air supply or

disturb the draught behaviour of your stove. Please ensure

the additional supply of fresh combustion air if necessary.

For details please consult your specialist retailer. Make

sure that the combustion air intakes are not blocked!

3. CORRECT OPERATION OF YOUR STOVE

Approved fuels

Dry, well cured and natural wood (hardwood preferred),

wood briquettes.

Maximum amount of fuel

Maximum amount of fuel to be added: 1,3 kg wood. Larger

amounts of fuel can lead to overheating and thus damage

the stove.

Clean burning

The wood must be dry (relative wood moisture < 15%) and

untreated and the right amount of wood must be burned in

order to ensure a clean fire that releases only small

amounts of emissions.

Startup procedures

During the first 3-4 operations - at nominal heat output -

there may be some odour development and the varnish

has not yet hardened.

Making a fire

For the correct and safe operation of your stove please

pay attention of the chimney developing the necessary

feed pressure. This must especially be considered before

the initial operation (or e.g. after the summer heating

break) and during the mid-season heating periods (e.g. at

strong wind, etc.).

If there is not enough feed pressure, please light only

some paper or small kindling first, in order to "warm up"

the stove and the chimney.

Clean grate, empty ash drawer if necessary (watch out for

ambers!)!

The air inlet must not be covered or closed.

Position the lever for the combustion air to the open ("AUF")

position (see fig. 3).

Place 2-3 logs (approx. 0,9 kg in total) crossways in the

combustion chamber with sufficient distance from each

other (min. 2 cm), on top of that place some softwood

chippings and some ignition aid and light.

Close the door!

Stove pipe connection

For your own safety stringent laws apply for connecting the

stove pipes to the chimney. Your professional dealer or

distributor knows these laws. Please have your certified

retailer carry out the connection of your stove

Fig. 3: before lighting

We recommend to let the first load burn down without

changing the air lever position.

As soon as no visible flames are left (only embers in the

combustion chamber), you can put another load of logs

(approx. 1,3 kg) in the combustion chamber if desired.

When reloading the stove please repeat the procedure as

mentioned under "first lighting": air lever position on "AUF" (=

open), open door carefully, place logs, close door.

After a few minutes, when the logs burn well on all sides

(bright, high flames), you can adjust the heat output with the

air lever (lever on max. position "AUF" = maximum heat

output), the flames should be yellow and never look blueish

or have black tips (otherwise add more air) – see fig. 4.

Never close air supply completely during operation. (danger

of flash-fire!)

The stove door may be opened only for refuelling or

disposing of ashes and is to be closed again afterwards.

Fig. 4: air knob

english