4tronix Singalong Kit Montagem - Página 9

Procurar online ou descarregar pdf Montagem para Robótica 4tronix Singalong Kit. 4tronix Singalong Kit 9 páginas.

Imprimir página
Step 16 – Wire in Audio Output and Switch Output
Use the Green, Blue and Violet wires to connect the Audio:
•
o Green to breadboard Negative rail
o Blue to breadboard Positive rail
o Brown to hole j8
For the switch, use the Black, White and Grey wires:
•
o Black to breadboard Negative rail
o White to breadboard Positive rail
o Grey to hole j20
You will now have 3 sets of GVS (Ground, Volts, Signal) leads to connect:
•
o Brown, Red, Orange: connect to output to drive the McRoboFace
o Green, Blue, Violet: connect to analog input for reacting to the audio
o Black, White, Grey: connect to digital input for reading the state of the switch. Will
require an internal pullup resistor
If using a Raspberry Pi with Picon Zero then connect as shown below
•
Now, please visit Robin Newman's blog:
rbnrpi.wordpress.com/project-list/mcroboface-singalong-with-sonic-pi
Singalong Kit Assembly