BENDIX TW-2 Instruções de instalação - Página 3

Procurar online ou descarregar pdf Instruções de instalação para Unidade de controlo BENDIX TW-2. BENDIX TW-2 4 páginas. Control valves maintenance kit

Imprimir página

REMOVAL

1. With the vehicle on a level surface, park the vehicle

by means other than the air brakes and drain all air

pressure from all reservoirs.

2. Identify all air lines and their connections to the valve

and disconnect.

3. Remove the two Phillips

plate to the valve and dash panel and remove the valve.

DISASSEMBLY

NOTE: Before beginning disassembly of the valve, mark

the relationship of the lever and cam to the body. The lever

must be placed back in the valve body in the same position

in order to ensure proper operation. DO NOT change the

lever position end for end. Most lever/cams have a locating

slot cut in them.

1. Remove the cap screws and lock washer and remove

the inlet plate. Note whether one or two inlet plate

o-rings (2) are used. *See note on page 1.

2. Remove and discard the o-ring (2), both springs (3) and

both inlet valves (4).

3. Remove the pin and lift the lever out of the body.

4. Remove both plungers and their return springs (5).

5. Remove the lever positioner and its spring, if the valve

is so equipped.

6. Remove the o-ring (6) from both plungers and discard

the o-rings.

ASSEMBLY

Prior to assembly, clean the lever and valve body in

mineral spirits and dry thoroughly. Lubricate o-rings and

o-ring bores with the lubricant (7) supplied with this kit.

1. Install both inlet valves (4) and inlet valve springs (3) in

the valve body.

2. Install the o-ring or o-rings (see NOTE* on page 1) in

the valve body.

head screws securing the dial

3. Install the inlet plate and secure with cap screws and

washer. Torque to 50-180 in-lbs.

4. Install the o-ring (6) on the plungers.

5. Install the plunger return springs (5) and install the

plungers in the valve body.

6. Install the lever positioner spring and lever positioner if

valve is so equipped.

7. Note the markings made on the lever/cam and valve

body during disassembly and position the lever in the

valve body.

8. Install the pin to secure the lever/cam.

OPERATING AND LEAKAGE CHECKS

Connect a 100 psi air source to the supply port(s) and

connect an air gauge to each delivery port. With the lever

in the number 1 position, as noted in Figure 3, apply a soap

solution to the exhaust openings in the valve body. No

leakage is permitted. Note which delivery gauge registers

pressure (if either do). Move the lever to position 2, if the

valve has this position, and wait 20 seconds before applying

a soap solution and checking the delivery port gauges.

Repeat this procedure for position 3.

INSTALLATION

1. Remount the valve in the dash panel using the two

Phillips head screws to secure the dial plate and valve.

2. Noting the air line identification made during removal,

reconnect the air lines to the proper ports.

3. Before moving the vehicle, build the air system pressure

and operate the valve to determine if it functions

properly in the system. If operation is incorrect, check

the lever/cam installation and the air line connections.